How can you tell the difference between a Dana 35 and a 44?
The easiest way to tell these axles apart is to look at the shape of the differential cover. The Dana 35 cover is pretty much perfectly round. The Dana 44 is sort of a six-sided shape. A Dana 35 (left) compared to a Dana 44 (right).
When did Jeep start using the Dana 44 axle?
Earlier CJ-2As and CJ3As did not use the Dana 44. Starting in 1972, the Dana 20 transfer case was used which has the rear output shaft centered, so the rear axle has the differential in the center. From 1972-1975 the Dana 44 was used with a 30 spline flanged axle shaft.
What’s the difference between Dana 30 and Dana 35 axles?
The Dana 30 gear ratios are either 3.21 or 3.73. The width of the axle shafts is 1.13 inches. The YJ Dana 30 hold a reverse cut ring and pinion, but the TJs do not. Both TJs and YJs, however, use a 5×4.5 inch bolt pattern. Dana 35: This was an axle size used on most Jeep rear axles. They had a ring gear diameter of 7 and 9/16 inches.
Which is the best rear axle for a Jeep Wrangler?
The Dana 30 will only be found as a Jeep front axle while the Dana 35 will only be found as a rear axle on Wranglers. Dana 35 axles have earned a very poor reputation in the off-roading world, however, it is a great axle for stock Wranglers.
What’s the difference between Dana and JK Rubicon axles?
JK Rubicon models have a thicker, slightly redesigned 44. This Rubicon axle is referred to as a Super Dana 44. Dana 44 – For TJs, the inner and outer axle has 30 splines. JK Rubicon model front axles have 30 inner splines and 32 outer splines.
How can you tell if a Dana axle is under a jeep?
You may be unsure which axle is under your Jeep, or maybe you’re purchasing a Jeep and want to know which axle it has. There are a few things that can help you tell if the axle is a Dana 35 or a Dana 44. The easiest way to tell these axles apart is to look at the shape of the differential cover. The Dana 35 cover is pretty much perfectly round.
The Dana 30 gear ratios are either 3.21 or 3.73. The width of the axle shafts is 1.13 inches. The YJ Dana 30 hold a reverse cut ring and pinion, but the TJs do not. Both TJs and YJs, however, use a 5×4.5 inch bolt pattern. Dana 35: This was an axle size used on most Jeep rear axles. They had a ring gear diameter of 7 and 9/16 inches.
What kind of axle does a Jeep Wrangler JK have?
TJs come with a Dana 30 or a Dana 44 in the front and either a Dana 35 or a Dana 44 in the rear. Typically the Sport and Sahara models include the Dana 30-Front/Dana 35-Rear. 2007-2018 Jeep Wrangler JK
Is the Wrangler YJ a Dana 44 wheel?
The Wrangler YJ never had a Dana 44 from the factory except in Canada. In the US, it always came with the Dana 35c. Since the YJ uses the smal 5 on 4.5″ wheel bolt pattern, swap options are much more limited if the wheel bolt pattern is to be retained.