Do you replace the front expansion valve at the same time?
As such, if you’re replacing the front expansion valve, it’s a good idea to replace the rear at the same time. This increases overall efficiency of the system, reduces the potential of small component failure and allows the parts you replaced to last longer.
What should I replace my AC condenser with?
Replacing AC condenser, drier, expansion valve and compressor. How much oil to add?? | Tacoma World Welcome to Tacoma World!
How can you tell if an expansion valve is clean?
It is very difficult to determine if a Thermostat Expansion Valve is clean. The only way to be sure the valve is clean is to put it back into operation and run a system performance test. If there is any malfunction, the unit must be disassembled again to change the valve.
What’s the best way to replace an AC compressor?
Add the specified amount for the components you are replacing. It would be a good idea to pour out as much oil from your old compressor as you can and measure it to make sure you put the same amount into the new one. I just looked up the spec on Mitchell.
Do you need expansion valves when installing a compressor?
Frankly you didn’t need the condenser and expansion valves either unless there is something wrong with those parts. Since you are installing a new compressor, make sure you evacuate the a/c lines once the compressor is installed and before you charge it with refrigerant.
How much does it cost to replace an air conditioner expansion valve?
Not only can this problem cause your home to get too cold, but the compressor will wear out faster and eventually break down sooner than expected. It can cost up to $1,800 to replace an A/C compressor, whereas replacing the expansion valve only costs up to $440.
As such, if you’re replacing the front expansion valve, it’s a good idea to replace the rear at the same time. This increases overall efficiency of the system, reduces the potential of small component failure and allows the parts you replaced to last longer.
Do you need to replace the expansion valve on a drier?
If the system has been open to the atmosphere (due to the leak in the condenser), the desiccant in the drier has been fully saturated with moisture. As far as the expansion valve, replacement is not normally implicated in a leak repair, in your case a leak in the condenser.