Who makes a load and go washer?
Whirlpool
The Load & Go™ Dispenser featured in select Whirlpool® Washing Machines lets you skip adding detergent to every load. The Load & Go™ Dispenser is designed to store enough detergent for 20–40 loads of laundry,1 depending on the washer model.
Does the wonder washer have a spin cycle?
The Wonder Washer is compact and is designed to clean a small load of washing, quickly. The Wonder Washer does not feature a spin cycle. How to use: simply plug-in and wash, it’s as easy as 1,2,3. Plug in the Wonder Washer machine to a standard outlet, fill with your laundry, add soap and water, then close lid.
What is a closet depth washer?
This configuration—which Whirlpool calls “closet-depth”—gives you about two extra inches of wiggle room over standard Whirlpool front loaders, which tend to be a little under 33.5 inches. The closet-depth machines also require an inch and a quarter less clearance for the door to open fully.
How much detergent does load and go use?
A Whirlpool Load and Go washing machine comes with a reservoir cartridge that holds up to 18.5 oz of detergent, which can do up to 36 loads of laundry if you’re using 6X concentrated detergent, or at least 12 loads with lower concentrations!
How do I turn off Whirlpool load and go?
To disable the Load & Go™ system and use only a single dose of HE detergent, press the Load & Go™ button until the light turns off. Pour measured amount of liquid HE detergent into the single dose detergent dispenser. The detergent will dispense at the optimum time during the wash cycle.
Where does the detergent go in a washing machine?
For the best results, make sure you put the detergent and softener into the right sections of your detergent drawer. The powder detergent goes into the largest section of the drawer, usually on the left hand side. If in any doubt, check your washing machine’s manual.