Where is the throttle cable on a Harley Davidson?
Install the heated hand grip/throttle sleeve, throttle cables and switch housing onto the right side of the handlebar per service manual procedures. 4. Remove the black ring from the inboard end of the left side heated hand grip (1). Insert the connector from the right side hand grip into the left side grip connector. 5.
How big is the throttle grip on a Harley Davidson?
Harley offers various handlebar bends for the new system. For certain applications they also offer a throttle-grip sensor with longer wires (43-1/4 inches long, Part No. 32308-08, $89.95), which connects directly to the stock wiring harness without an extension harness.
Where is the throttle grip sensor on a Harley Davidson?
The throttle-grip sensor is keyed to the handlebar with a series of notches cut into the bar that mate with bosses on the throttle-grip sensor. The throttle-control actuator includes a geared, permanent-magnet DC motor, and two sealed automotive-style throttle-position sensors mounted to the side of the throttle body.
When did electronic throttle control come out for Harley Davidson?
Harley-Davidson Electronic Throttle Control. In 2008 Harley-Davidson introduced a new throttle system called Electronic Throttle Control (ETC), which eliminates the throttle cables connecting the throttle and the throttle body and replaces them with an electronic connection.
How do you change the throttle grip on a Harley?
adjust the throttle cable adjuster so that the throttle body butterflies hit the wide open stop just as the throttle grip reaches wide open throttle (WOT). snug the lock nut on the throttle cable adjuster. adjust the idle cable adjuster to remove excess slack from the throttle grip, but not so tight as to cause the grip to bind.
Harley-Davidson Electronic Throttle Control. In 2008 Harley-Davidson introduced a new throttle system called Electronic Throttle Control (ETC), which eliminates the throttle cables connecting the throttle and the throttle body and replaces them with an electronic connection.
How does the throttle grip sensor work on a Honda Accord?
The unit is spring loaded to return to idle, and includes two sets of magnetic sensors that send signals to the electronic control module. The throttle-grip sensor is keyed to the handlebar with a series of notches cut into the bar that mate with bosses on the throttle-grip sensor.
What should the idle speed be if the throttle is turned off?
If the ignition is turned off with the throttle in a position other than 0 percent throttle, the system wants to use a higher rpm as the new idle speed the next time the engine is started. If you shut the bike off at 1,800 rpm, the next time you start the engine it will use approximately 1,400 as the new idle speed.