Where is the spoiler on a Honda Accord?
Honda Accords that are not manufactured with a factory spoiler have rubber grommets in the spoiler mounting locations. Once you remove the trunk liner, the areas for the pilot holes will be made visible. Disconnect the negative (black) terminal of the battery.
How do you remove the TPS from a Honda Accord?
Simply use the ratchet with a 5 mm socket to remove the TPS. Position your new TPS sensor on the throttle body. Thread each 5 mm bolt (16 mm in length) into the slots that secure the TPS. Use a locking washer and nut on the opposite end of the bolts to fasten.
How do I replace my cigarette lighter on my Honda Accord?
1. Make sure you have the anti-theft code for radio, then write down the frequencies for the preset buttons. 2. Set the parking brake. On AT Model: Move the shift lever to the “1” position. 3. Disconnect the negative cable from the battery. 4. Attach a piece of masking tape onto the console panel below the clock. 5.
How do you change the starter on a Honda Accord?
Disconnect the starter wires. Unbolt the starter from the block by using a wrench. Hold on to it in order to keep it from dropping on you. Use paint or chalk to mark the ring gear points and the equivalent spot on the hole. Turn the engine one full revolution with a screwdriver while checking the ring gear’s teeth.
How to replace the motor mount on a Honda Accord?
In this video, Raef Eagan gives us a simple tutorial on how to replace a cracked, broken, or worn-out motor mount on a 1999 Honda Accord. This will restore the smooth-functioning of the vehicle whilst cranking the engine or switching on the air conditioning. The new motor mount cost Raef a measly $17 and saved him a fortune on labor costs.
What should I do if my Honda Accord head gasket is warped?
The new gasket won’t mean much if the head is warped. Thoroughly clean the head bolts and stud threads that secure the cylinder head and lightly lubricate with engine oil prior to re-installation. This will reduce strain on the cylinder head and engine block.
How do you replace the alternator on a Honda Accord?
Tighten all alternator mounting bolts to 16 ft-lbs using a torque wrench. Connect the electrical plug. Press it on until it clicks into place. Re-connect the fan electrical plug to its holder. Press the power steering reservoir back into its clip. It is recommended to replace your serpentine belt at the same time as the alternator.
Disconnect the starter wires. Unbolt the starter from the block by using a wrench. Hold on to it in order to keep it from dropping on you. Use paint or chalk to mark the ring gear points and the equivalent spot on the hole. Turn the engine one full revolution with a screwdriver while checking the ring gear’s teeth.