Where does the spark go on a Honda XL?
It goes from the stator, splits and goes to the coil and the points. It also goes to the kill switch and the key switch, but you should have already tried unplugging both the key switch and kill switch to rule them out.
What can I use to Clean spark points on Honda XL?
Try cleaning the points with an extreemly fine grit of sandpaper, or some rough paper (ie- buisness card). Pry them open, insert the paper, let them close, and work the paper back and forth. You may have to repeat this proccess a few times using different spots on the paper to get them clean.
What should I do if my Honda XL light is not working?
Assuming the light worked okay on the points, the only thing left is a coil. I kid you not, the test procedure in the manual is, “lay the plug on the head and kick. If you’ve got spark, the coil is good. If not, get a new coil”.
Can a Honda XL run without a Kill Switch?
Unplug the key switch and ignition switch. The bike will run without them, but if the key switch is unplugged, none of the lights will work. The kill switch is a bit harder, you’ll have to trace it either to inside of the headlight bucket or to a bundle of wires above the engine. Did that solve your problem? No? Step 2.
How to measure no spark on a Z50?
Disconnect the stator plug from the coil plug. Connect the red lead of your meter to your black Stator wire. Connect the other lead of your meter to the frame/ground. When you kick the engine over, you should get and ac voltage (actually a pulsing DC) that approaches 6 volts, however, I would measure it using the dc range.
What should I do if my Honda Accord has no spark?
In this case, the owner replaced the fuel pump, but the problem was elsewhere. Don’t be discouraged when this happens. Although it costs more money when you have to replace multiple parts in your car to solve a problem, this is the burden of the DIY mechanic. And think of all the money you’ve saved by working on your own car!
How to trace down my no spark condition?
Discussion in ‘ Tech Area ‘ started by silverz50, Feb 3, 2009 . ok guys i have a new stator points plug etc.. black and red.. red going to the lights and black for ignition.. my understand is that the black should give 6v AC current to the coil. when the ign switch is off it make ground to the coil and shutting it off..
What to do if your car has no spark?
Well for no spark, forget about the red stator wire. Your concerned with black wire only. Disconnect the stator plug from the coil plug. Connect the red lead of your meter to your black Stator wire. Connect the other lead of your meter to the frame/ground.