Where can I change oil on my Briggs and Stratton lawn mower?
Also, you can drop it off with a participating Briggs & Stratton service dealer. Rather than tipping your mower to change the oil, you may utilize the Oil Drain which is very effective, but can be difficult to locate on the underside of your mower.
How do you change the oil on a motorcycle?
Put your bike on the side stand, center-stand or rear-stand if you have one. Put your drain pan approximately under the bolt. Try to think ahead of where the oil’s going to shoot out, and watch it as it drains. You’ll most likely have to adjust the placement of the drain pan as the old oil slows down. Use the proper tool to remove the bolt.
Where is the oil drain plug located on a vertical shaft engine?
Typically, however, on vertical shaft engines, the oil drain plug is located beneath the engine block near the crankshaft. To remove the square plug, all that is required is a standard size 3/8″ ratchet and extension (no socket). On horizontal shaft engines it would be located below the centerline of the crankshaft, on the base of the engine block.
How do you change the oil level in a car?
1. Set machine on a level surface. 2. Clean the area around the dip stick. 3. Start and run engine for 20-30 seconds. This will return oil to its true level in the oil tank. 4. Stop engine, remove dipstick (A) and wipe dry with a clean cloth. 5. Reinstall dipstick, screw the dipstick into place.
Do you need to change the drain plug every oil change?
If the drain plug and washer (if equipped) is properly re-installed after an oil change, they do not need to be replaced with a new one with every oil change. You don’t need to replace the drain plug but it’s smart to replace the drain plug gasket with each oil change.
What’s the best way to do an oil change?
Make sure the cap, drain plug and oil filter are all secure. Start the engine (outdoors or in a well-ventilated area), let it run a few minutes, turn off the engine, and then let it sit. Check the oil level again. Top-off if necessary and check one more time for any possible leaks. Clean up any spilled oil.
Where is the oil drain plug on a riding lawn mower?
Look under the mower deck for the oil drain plug.Most are square & recessed for a socket wrench set,socket extension fit (3/8’s) drive.Others may be just a common drain plug or bolt Either prop the mower or hold up & use the socket to loosen the drain plug or bolt.Be sure to have a drain pan under the deck to catch the used oil.
How do you change oil on a Briggs and Stratton riding mower?
Tilt the mower deck with the air filter or spark plug side up, and position some newspaper and an oil pan or jug beneath the mower. Use a 3/8″ drive socket wrench and extension (no socket) to turn the plug counter clockwise (see photo at right), allowing the old oil to drain.