Where are the plugs on a BMW door?
1. Plug for rear section to driver’s door (5-pin) 2. Plug for rear section to center section (27 –pin) 3. Plug for window control and central lock wire to driver’s door(13- pin) 4. Plug for window control and central lock wire to special equipment plug 5. Window switch rear left 6.
How do you rewire a Honda Civic door?
Figure 2. Separate the passenger’s side door harness. Figure 3. Locate the light gray plug (circled in red). With your wire cutters, completely cut off and discard the dark gray plug. With the remaining light gray plug, cut and strip the brown/black and red/green tracer wires at the base of the plug. These are the speaker wires.
Where are the power doors on a Honda Civic?
From a donor Honda Civic EX or Si (1996-2000) with power doors, locate the wire harnesses in the driver’s and passenger’s side foot wells. These wire harnesses run though the interior cabin floor, and connect to the under-dash fuse box. Locate the plugs that connect to the hinged end of the driver’s and passenger’s side doors.
Which is the wiring diagram for a BMW?
BK Black BL Blue BR Brown GE Yellow GN Green GR Green or Grey GY Grey OR Orange PK Pink R Red RS Pink RT Red SW Black TN Tan V Violet VI Violet W White WS White Y Yellow Diagrams index
Why is my passenger window not working but the driver window is working?
When passenger windows don’t work, but the driver’s window does, chances are high that you’ve got a bad master switch in the driver’s door or a broken wire in the driver’s door hinge area. Second: Power window motors only have two wires.
How many wires does a power window motor have?
Second: Power window motors only have two wires. When you operate the down cycle on your power window switch, it provides + power and – ground to the power window motor. When you operate the up cycle, the switch reverses the polarity on those same two wires.
1. Plug for rear section to driver’s door (5-pin) 2. Plug for rear section to center section (27 –pin) 3. Plug for window control and central lock wire to driver’s door(13- pin) 4. Plug for window control and central lock wire to special equipment plug 5. Window switch rear left 6.
What kind of wiring do you need for a keyless entry system?
To make a keyless entry system work you can create the circuit above using (2) #778 realys but it’s recommended to use the XK09 or DB-ALL. NOTE *2 the YELLOW Parking light wire will require a (-) Negative thru a 1300 Ohm resistor and a extra relay part #775, to connect, See DIAGRAM.