When to replace timing belt and water pump on Toyota Camry?
Save yourself a bundle by doing some general maintenance on your Camry’s engine yourself. This article applies to the Toyota Camry (1997-2011). Many Camry owners dread the 60,000 mile marker because of the costly timing belt and water pump recommended maintenance interval.
Can you replace the timing belt and water pump at the same time?
It’s best not to gamble in a situation like that and just get the water pump replacement done at the same time as the timing belt. If your car is already on its second timing belt replacement, you’ll probably want to replace the water pump and other belts at the same time. Another consideration is what kind of engine your car has.
How does the timing belt work on a Toyota?
Timing belts typically snake around idler pulleys and a special tensioner, and on most timing belt engines, the timing belt will drive the water pump, and on some, the belt even spins the oil pump (see 2.2L Toyota engines).
Do you replace the water pump at the same time?
Considering that water pumps generally do not cost a lot, it makes sense to do both at the same time. Not replacing the water pump on these vehicles during a timing belt change means if the pump does go at a later point, you will have to pay for the same labour again.
What’s the life expectancy of a Toyota water pump?
Anywhere between 90-120k, usually done at timing belt change to save time. I also get my thermostat done at the same time. If your timing belt fails in a non-interference engine, you’ll be stranded on the side of the road, if your water pump fails you’ll either a)be left on the side of the road or b)cause engine damage.
What happens if your Toyota water pump fails?
If your timing belt fails in a non-interference engine, you’ll be stranded on the side of the road, if your water pump fails you’ll either a)be left on the side of the road or b)cause engine damage. Peace of mind is worth something, that’s why we’re willing to pay more for a Toyota :whatwhat:
When to replace timing belt on Toyota Tundra?
Tundra If you own a 2000 to 2004 V6 Tundra get ready for a replacement by 60k miles. For a 4.7 V8 engine made between 2000 and 2009, prepare to replace the belt when the mileage reaches 90k miles.
How do you replace a power steering belt on a Toyota Camry?
Remove the bolts to get access to the air conditioning and power steering belts. Use a wrench to put onto the tensioner pulley (12 mm bolt) to create slack in the belts and remove each belt. Inspect them for cracking or wear and replace with new ones while you have them off. Figure 6. Remove the power steering and air conditioning belts.
Where are the tensioner bolts on a Toyota Camry?
Two bolts are used to adjust the tension on the belt. They are at 90 degrees in relation to one another. They both need to be loosened, but do not need to be removed. The tensioner bolt on the left hand side is difficult to get to.
What happens if you have a broken timing belt?
The last thing you want to do is to strand yourself because of a broken timing belt or busted water pump. Being stranded is the least of your worries at this point. Driving in either one of these conditions can lead to serious engine damage and a major repair expense.
How long does it take to replace timing belt and water pump?
Expect to spend approximately three hours replacing the timing belt, guide pulley, and tensioner pulley alone. Replacing the water pump adds about a half hour, and replacing sprocket seals adds about a half hour per seal.
What happens if the timing belt breaks on a Camry 5sFE?
The 5SFE is a “non-interference” engine, meaning that if the belt breaks while the car is running, the valves and pistons are unlikely to be damaged. Thus you can use these instructions to replace a broken timing belt, as well as one that is just due to be replaced.
What happens at the 60, 000 mile mark on a Toyota Camry?
This article applies to the Toyota Camry (1997-2011). Many Camry owners dread the 60,000 mile marker because of the costly timing belt and water pump recommended maintenance interval. The last thing you want to do is to strand yourself because of a broken timing belt or busted water pump. Being stranded is the least of your worries at this point.
What causes oil leak in Toyota Camry 5sFE?
Oil leaks from the vicinity of the passenger-side front wheel may indicate a need to replace the timing belt and seals. The 5SFE is a “non-interference” engine, meaning that if the belt breaks while the car is running, the valves and pistons are unlikely to be damaged.
How often do you need to replace timing belts on a Toyota?
Some Toyota engines have timing belts, some have timing chains. It pays to know what your engine has. Belts need to be replaced at normal intervals (usually every 90-100k on late model cars) or you will have hell to pay. Timing chains however are a different story and will generally last the lifetime of the engine.
How do you remove a pulley from a Toyota Camry?
If you are extremely lucky, the pulley will come off by hand once you remove the two smaller bolts that hold it in place. This is likely not going to be that easy. You will want to use a pulley removal kit that can be had pretty cheaply. Make sure you use one like in the figure below.
Is the water pump on my 1997 Camry running hot?
Vocational, Technical or Tra… I have a 1997 Toyota Camry that water pump was recently changed on. It is running hot after about 15 minutes but if you try to put water in the … read more Automotive Diagnostic Spe… Have my daughters 1997 Toyota Camry and the heater core is hot but no warm air in cab occurs.
How to replace the water pump on a 1997 Toyota?
Remove the alternatordrive belt adjusting bar. Remove the 2 nuts holding the water pump to the water bypass pipe and remove the 3 bolts in sequence. Disconnect the water pump cover from the water bypass pipe and remove the water pump cover assembly. Remove the gasket and 2 O-rings from the water pump and the bypass pipe.
When to replace timing belt on Honda Civic?
Parts such as pulleys, serpentine belts, tensioners and the water pump are usually worth replacing if they show wear or signs of failure. These repairs are not included in the estimate above. How does the timing belt work? The teeth on the belt mesh with the crankshaft timing gear and camshaft timing gear.
https://www.youtube.com/watch?v=Lj2AZD74Yg0
What happens if the water pump fails on a Toyota Camry?
If the pump fails, your engine’s coolant supply will fail to cycle through the engine, likely causing overheating and damage. This article applies to the Toyota Camry 5th and 6th generation (2002-2011).
What kind of engine does a Toyota Camry have?
The Toyota 5SFE motor is a four-cylinder, 2.2 liter, timing-belt-driven, double overhead cam (DOHC) engine design. This motor is commonly found in the Camry, Celica, MR2 and RAV4 from 1990 to 2001. (For a six-cylinder Camry, see my article on MZFE timing belt replacement). 5SFE timing belt diagram
When did Toyota Camry stop having timing chain?
From 2002 to 2021 all Toyota Camry 4 cylinder models had a timing chain and interference engine. The 4 cylinder Camrys from 1990 to 2001 had timing belts and non-interference engines. Scroll down for detailed information on your particular model year. Check Out Belt Or Chain For Other Makes And Models
Why do you need to change your timing belt and water pump?
This might be preceded by a ticking noise coming from the engine bay. In addition, the gasket separating the timing cover and engine block may fail over time, causing oil to leak out. It is technically possible to replace your car’s timing belt and water pump yourself.
What happens if the timing belt fails on a Porsche Cayman?
And if the timing belt fails, whether due to simple age, or the failure of a tension pulley or bearing, the water pump will likely fail along with it. Also, as with the Porsche Cayman’s RMS, the water pump isn’t easy to get at. In fact, ClickMechanic and NAPA explain, you can’t get at the water pump without first exposing the timing belt.
Is the timing belt on a Camry 3mzfe interchangeable?
Most engine components in the 1MZFE are interchangeable with the 3MZFE, including the timing belt, tensioner pulley, and guide pulley, although the 3MZFE has a different tensioner configuration. See my other article for replacement of a timing belt on the four-cylinder Camry (the 5SFE engine).
When to replace timing belt and related parts?
When to Replace the Timing Belt and Related Parts. Toyota recommends belt replacement after 90,000 miles. Other parts are often replaced at the same time. Some shops always replace the water pump with the belt, but in my experience the Aisin water pumps that come with the MZFE Camry are good for at least 200,000 miles.
https://www.youtube.com/watch?v=Hos55S3Qmpg
What kind of parts does a Toyota Camry use?
If you want to use Japanese OEM (Original Equipment Manufacturer) parts–the parts that Toyota puts its own label on–you will want a Mitsuboshi timing belt, Koyo pulleys, and an Aisin water pump. Other Japanese OEM brands include Denso, NGK, KYB, Akebono, GMB, and Sumoto.
When to change timing belt on Volvo 960?
See 960 Timing Belt Changefor important information regarding the timing belt change interval – which varies by model year for the 960 series – as well as the tensioner and idler pulleys which, upon failure, will destroy the belt and the cylinder head at great cost.