What is the warning switch on a Toyota Land Cruiser?
IGNITION SWITCH AND KEY UNLOCK WARNING SWITCH: This system uses the body control system, so check the body control system before you proceed with troubleshooting ( DI-1038 ). Ignition switch is not set to each position. 4. Ignition switch 5. Power source circuit
Are there any problems with the Toyota Landcruiser 80 series?
If you own a diesel 80 Series, whether it be a 1HZ or 1HD engine, it’d be worth having your big end bearings looked at. They’re known to have issues from the factory, and with the old 80s getting on in age, if they’ve not been looked at before, now would be the time.
Why are the lights on on my Toyota 94?
My 94 pickup was having the same issues; marker lights on, dash lights on, and the annoying beep even with no keys in the ignition. It turned out to be the tail relay. I love when it turns out to be something simple.
What causes a battery light to go on on a Land Cruiser?
Going by the wiring diagram, battery voltage will only appear on that terminal if it is via the warning lamp. If this puts the lamp on, the problem is between the CHARGE fuse holder and the alternator, or the alternator, or the alternator / engine earth.
Why does my Toyota Land Cruiser fan stop working?
Immediately after is pressed, the fan may stop for a while until warm or cool air is ready to flow. Cool air may flow to the area around the upper body when the heater is on. The windows will fog up more easily if the recirculated air mode is used for an extended period.
What is the body control system on a Toyota Land Cruiser?
HEADLIGHT AND TAILLIGHT SYSTEM: This system uses the body control system, so check the body control system before you proceed with troubleshooting ( DI-1038 ). “Automatic light control system” does not operate. 1.
When did the Toyota Land Cruiser 80 series come out?
The 80 series Land Cruiser also showcased full-time four-wheel drive in North America and Europe. The 80 series would go on to include such standard Land Cruiser parts as airbags and anti-lock brakes in 1996.
Why does my tail light not come on?
Taillight does not come on with light control switch in TAIL. 1. Engine Room J/B Relay Circuit 2. Light Control Switch 3. Wire Harness Taillight does not go out with light control switch in OFF. 1. Engine Room J/B Relay Circuit 2.
How do you unlock a Toyota Land Cruiser?
Unlocks all doors Turning the key rearward unlocks the driver’s door. Turning the key once again unlocks the other doors. *: This setting must be customized at your Toyota dealer. Shift the shift lever to “P” and apply the brakes.
What to do if your Toyota Land Cruiser won’t start?
Don’t worry, you can still start your vehicle – the battery is only used to send the signal for locking/unlocking. If the key fob battery is empty, the door no longer locks or unlocks at the push of a button. The doors must then be opened manually. The immobilizer is controlled by a passive transponder.
When to replace battery in Toyota Land Cruiser?
As this above procedure is a temporary measure, it is recommended that the electronic key battery be replaced immediately when the battery depletes. Using the mechanical key to lock the doors will not set the alarm system. If a door is unlocked using the mechanical key when the alarm system is set, the alarm may be triggered.