What is the purpose of an aligning tool when installing a clutch assembly?
The tip of the clutch alignment tool locks into the bearing, keeping your clutch in place. The clutch has two sides, one side is usually marked to the flywheel, they must be installed correctly.
What happens if clutch not aligned?
If clutches have not been correctly aligned, they will start juddering or fail to disenga- ge immediately afterwards. The clutch should thus always be checked for correct alignment on the flywheel. Grease that contains no suspended particulates should be used for lubricating splines and release bearings/guide tubes.
What happens if you don’t use clutch alignment tool?
When installing a clutch it is necessary to align the disc with the flywheel before installing the cover (pressure plate). If you don’t, the input shaft from the transmission will not engage the disc properly and you will never get the transmission lined up and installed!
What happens if clutch is not aligned?
Does the flywheel need to be replaced with the clutch?
As you drive a manual transmission car, the clutch is constantly coming in contact with the flywheel when you release the clutch pedal. If the flywheel is too worn and cannot be resurfaced, then it is advisable to replace the whole thing with a new part.
Can you install clutch without alignment tool?
There you have it! Installing a clutch with a clutch alignment tool is definitely preferred, and in some cases may be required. But for many installs, a little ingenuity is all you need to install your clutch without relying on tools you don’t need.
How do you replace the clutch on a Toyota Camry?
When replacing the clutch, it is best to purchase a clutch kit, which contains the clutch, disc, release bearing, alignment tool and spline lube. Disconnect the battery ground cable with a wrench. If your Camry has an airbag, wait 90 seconds before proceeding. Disconnect the battery’s positive cable. Remove the battery with the appropriate sockets.
Can a Camry wheel alignment kit be installed?
Most tire and alignment shops will check the alignment angles of all four wheels. However, your Camry, unless a camber adjusting kit is installed, won’t have adjustable rear camber.
Can you adjust the camber on a Toyota Camry?
Rear Camber. Most tire and alignment shops will check the alignment angles of all four wheels. However, your Camry, unless a camber adjusting kit is installed, won’t have adjustable rear camber.
How do you adjust toe angle on Toyota Camry?
Toe angle is adjusted by loosening and turning the tie rod adjusting sleeves under your car. There are two adjusting sleeves on your Camry: one on the passenger side and one on the driver side.