What is the part number for a VW rear seat release latch?
The part number is 1J0-885-643-E, you will also need the color code, for black the color code is B41, Grey is U71, Beige is Q70. The parts department should be able to help you out using the part number listed above.
Where is the red handle on a Honda Accord?
The red handle of the valve is located near the left rear tire and the splash guard on 1998-2005 models and in front of the left rear tire on 2006 and later models. To access the handle, reach around the front or rear of the left rear wheel, depending on the model.
Why is my rear seat release latch broken?
In the picture below, you will notice how one of the prongs has broken off the end of the rod. That is what has been keeping the latch from releasing the seat. Tip: Only pull out the handle, do not try to pull out the whole plastic cup as it will likely break.
How do you replace the back seat handle?
The best method that I found to do this is to get into the back seat with it folded down. Insert your new handle/Rod. Put a finger or two in the little hole and pull the latch up as far as you can. With your other hand press down hard onto the handle till it pops back into the latching mechanism.
The part number is 1J0-885-643-E, you will also need the color code, for black the color code is B41, Grey is U71, Beige is Q70. The parts department should be able to help you out using the part number listed above.
In the picture below, you will notice how one of the prongs has broken off the end of the rod. That is what has been keeping the latch from releasing the seat. Tip: Only pull out the handle, do not try to pull out the whole plastic cup as it will likely break.
The best method that I found to do this is to get into the back seat with it folded down. Insert your new handle/Rod. Put a finger or two in the little hole and pull the latch up as far as you can. With your other hand press down hard onto the handle till it pops back into the latching mechanism.
Can you upgrade the seat on a Honda Shadow?
Make your rides smoother and more enjoyable by upgrading your Honda Shadow Seat and Honda Shadow backrest at jpcycles.com. Not only are these seats comfy to sit on, they upgrade the whole appearance of your Honda Shadow. Be sure to check out our seat options from top makers like Saddlemen, Mustang, Cobra, Drag Specialties, Le Pera, and many more.
What happens if you break the middle seat latch on a Honda Pilot?
Honda did not in any Wisdom create a backup hole to move your cable from hole A to Hole B. It is simply the same lever used on the right and the left seats. The left uses both holes and the right uses only one of the two. If you break the lever on the Right side seat you have the option to use an unused hole. On the Left side seat – no dice.
Do you need a lever to move a power seat?
This means that you will not anymore move it through the use of levers. For more practical use, the power seats typically go with particular memory options. This type of seat is the replacement for bar or lever type front seat.
Honda did not in any Wisdom create a backup hole to move your cable from hole A to Hole B. It is simply the same lever used on the right and the left seats. The left uses both holes and the right uses only one of the two. If you break the lever on the Right side seat you have the option to use an unused hole. On the Left side seat – no dice.
Where are the Phillips head screws on a Honda Pilot?
3) next step is to take out the screws (@ located in red ) They are all phillips head with the exception of the one located at the bottom of the seat, it’s a torx head screw. You have to pull back the plastic cover on the arm between the back of the seat and the seat cushion to get at the torx screw.
How can I get my Honda Pilot to fold down?
1) pull the back panel off the seat. There are plastic plugs ( @ where indicated in green ) attached to the back of the seat. Start at the bottom. These plugs press into holes in the metal frame of the back of the seat.
What to do if rear seat release latch has broken?
Once it releases, completely pull that piece out. That is the piece you will be replacing (known as the rod). In the picture below, you will notice how one of the prongs has broken off the end of the rod. That is what has been keeping the latch from releasing the seat.
Where is the latch on the back of the seat?
From your pics, it looks like the latch hole in back of the seat is partially exposed from the trunk. In mine it isn’t. It’s completely hidden…apparently nearer the outer edges/sides of the seat than on yours.
What to do if your rear seat is stuck?
Be sure to pull the seat lever while you’re pulling up with your diy tool, if at first you have trouble, keep going! You’ve got this! It’s important you have to have it in the right spot when you’re pulling up and if you try a bunch of times and it doesn’t work, try making a new tool.