What is the engine coolant sensor code in FMI?
110 2 PID 110 1212 Engine Coolant Sensor (OUT), General Temp. Plausibility Error SPN FMI PID/SID PID/SID ID FLASH CODE FAULT DESCRIPTION 132 7 PID 132 1213 Intake Air Throttle Valve Closure Detection- Positive Torque 132 14 PID 132 1213 Intake Air Throttle Valve Closure Detection -Braking Condition
What is the code for the coolant sensor?
110 0 PID 110 1212 Coolant Temperature High 110 14 PID 110 1212 Coolant Temperature / Engine Oil Temperature Plausibility Fault 110 2 PID 110 1212 Engine Coolant Sensor (OUT), General Temp. Plausibility Error SPN FMI PID/SID PID/SID ID FLASH CODE FAULT DESCRIPTION 132 7 PID 132 1213
What is the SPN code for a FMI PID?
SPN FMI PID/SID PID/SID ID FLASH CODE FAULT DESCRIPTION 132 7 PID 132 1213 Intake Air Throttle Valve Closure Detection- Positive Torque 132 14 PID 132 1213 Intake Air Throttle Valve Closure Detection -Braking Condition 132 14 PID 322 1635 HC-Doser Fuel Pressure Not Plausible 132 1 PID 322 1213 Air Mass Flow Too Low
What is the SPN code for a FMI Sid?
SPN FMI PID/SID PID/SID ID FLASH CODE FAULT DESCRIPTION 634 4 SID 40 1321 Constant Throttle Valve Circuit Failed Low 634 3 SID 40 1321 Constant Throttle Valve Circuit Failed High 634 5 SID 40 1321 Constant Throttle Valve Circuit Failed Open 636 1 SID 21 1235 Crankshaft Position Sensor Signal Voltage Too Low
What is the fault code for an ECU?
Engine ECU Faults (MID 128) Fault Code Description FMI Codes MID 128 PPID 326 Soot Level (DPF System) 0,11 MID 128 PPID 328 Aftertreatment Injection Shutoff Valve 3,4,5,7,14 MID 128 PPID 329 Aftertreatment Fuel Injector 3,4,5,7,14 MID 128 SID 254 Engine electronic control unit (EECU) 3, 8, 12
What is the Flash code for FMI 03?
The above picture shows us the column for “CODE” and “FMI”, but also gives us the “FLASH” code. On the code that is highlighted, you will see that we have a flash code of “26”, which also is PID 108 FMI 03.
What does FMI stand for in truck diagnostics?
FMI” is the Failure Mode Indicator. This number represents the type of failure detected. Refer to Failure Mode Indicators (FMI) below for more information. Active” or “Previously Active” will be displayed to identify whether a fault is currently active or if the fault was previously active. OC” is the Occurrence Count.
How to know if a DTC is not available?
Suspect parameter number (SPN), failure mode indicator (FMI) and occurrence count numbers are listed. Source addresses and DTC descriptions are presented in plain text. NOTE – The VID will display “Not Available” if a DTC description is not available for a particular fault.