What is the Allison Transmission recommended wire number?
Allison Transmission recommended wire numbers (i.e. 112) consist of three digits, where the first digit indicates the TCM 80-way connector number, and the last two digits indicate the pin-out information (i.e. 12).
How can I read the Nissan UD Flash code?
The trouble codes will be displayed by the flashing Engine Control Lamp and the Overheat Warning Lamp and the Overheat Warning Buzzer. Release diagnostic switch. Turn ignition On. Check that Overheat Warning Lamp is displaying Diagnostic Display Code. Connect memory clear connector 2400400Z09, or a suitable jumper wire to reset switch terminals.
Where do I find the trouble code on my Nissan?
Place diagnostic switch in the Off position. Carry out diagnosis under the following three conditions: Turn ignition On. Crank engine. Start and operate engine. The trouble codes will be displayed by the flashing Engine Control Lamp and the Overheat Warning Lamp and the Overheat Warning Buzzer.
How long does it take for a Nissan OBD code to appear?
For example, a code 12 will be displayed by the check engine lamp flashing 1 time for approximately 1.2 seconds, followed by a .6 second pause, then 2 short flashes. Each trouble code will be displayed 3 times before the next trouble code is displayed.
What does the Allison Transmission Control package do?
The Allison electronic controls package oversees the operation of the transmission, controlling transmission upshifts and downshifts, and providing important information on the operation of your drive system. Through readouts on your shift selector, you will be able to monitor transmission oil levels and read diagnostic codes.
Where are error codes stored on an Allison Transmission?
At the same time, the memory of the electronic control unit of the automatic transmission “ALLISON” (TCM, ECU) stores error codes that can be read either using the gear selector (up to 5 errors) or using the Allison DOC diagnostic program.
What is the Allison transmission fault code p0562?
Code P0562 ignition voltage 8.2v All wires check out ok. And voltage at plugin is 12+ volts.Grounds are all good. Battery voltage good.