What is airbag module?
An SRS airbag module, also known as the airbag electronic crash unit, controls the airbag’s deployment, stores crash data and exchanges information with the car’s engine. If your SRS module is faulty, your vehicle’s airbags may not protect you and your passengers in the case of an accident.
How much does it cost to replace an airbag module?
The average cost for an airbag control module replacement comes between $685 and $712 for most cars and locations. The labor costs for this procedure are estimated between $103 and $130, while the cost of the parts is more expensive at $582.
How do you know if your airbag module is bad?
You can easily tell if the sensor is functioning if the airbag warning light on the dashboard is illuminating every time you start the vehicle. But, if the airbag warning light stays illuminated after starting the vehicle, this is an indication of an airbag sensor problem.
How do you install an airbag control module?
All airbag srs components must be installed and connected properly before installing the airbag control module. This includes air bags, seat belts, clock spring and impact sensors. Disconnect the battery and bolt down the module and then connect the harness wiring plugs.
Where is the airbag module on a Hyundai?
This is a safety precaution. Located the module. It is usually located under the center console towards the back. You will need to remove the trim and the continue ti unbolting the unit and disconnecting the wires. Once removed you can reconnect the battery. Why is it important to reset the SRS airbag module?
How much does it cost to replace air bag in Toyota Highlander?
The average cost for a Toyota Highlander air bag control module replacement is between $583 and $609. Labor costs are estimated between $98 and $124 while parts are priced at $485. This range does not include taxes and fees, and does not factor in your specific model year or unique location.
Where is the SRS airbag control module located?
In most GM cars it is under the driver or passenger seat. Disconnect the positive battery cable and wait 3 min. You are now safe to unplug the airbag control module harness wiring plugs. All airbag srs components must be installed and connected properly before installing the airbag control module.