What does the OBD 2 fault code b1342 mean?
END OF SPECIAL NOTES. OBD II fault code B1342 is most commonly defined as “ECU (Electronic Control Unit) has failed”, or sometimes as “GEM (Generic Control Module) has failed”.
What does b1342 mean on a Ford ECU?
Note that in the case of Ford products, this code can refer to almost any controller that is not concerned with engine/fuel/transmission management functions. After proper recollection of that code, I remembered, it was a body code B1342. Which equals a antilock brake module failure.
What does b1342 stand for on a controller?
NOTE #2: In some cases, code B1342 does not specifically refer to any particular controller. Instead, the code definition as displayed on the scanner might refer to a system such as the ABS, air bags, or electronic power steering.
What are the symptoms of the code b1342?
Symptoms of code B1342 are mostly make-and-model specific, as are diagnostic and repair procedures. However, the most common symptom of this code across all applications is the presence of one or more illuminated warning lights, depending on which circuits/control modules are affected.
END OF SPECIAL NOTES. OBD II fault code B1342 is most commonly defined as “ECU (Electronic Control Unit) has failed”, or sometimes as “GEM (Generic Control Module) has failed”.
What does it mean when your ECU says b1342?
B1342 – ECU Is Defective. B1342 Possible Causes. The B1342 code means that the Electronic Control Unit (ECU) has failed, usually the code is combine with other issues or codes.
What are the common causes of code b1342?
The actual number of control modules on any given application depends on the make and model, but code B1342 generally applies to all body control issues on all applications. The image below shows the typical systems and/or controllers that are covered by code B1342. What are the common causes of code B1342?
Where is the b1342 fault code stored in the ABS module?
Also found a company that re-mans units and will send yours back to you if you send it in. Was Bosch the OE Supplier for Ford for these modules? Thanks! B1342 means there is a configuration error in the module you are scanning – in this case, since you selected ABS, the code is stored in your ABS module.