What does EC mean on my Mercedes?
EC button on your ac and heating control is to bring outside air only into your car. when that mode is selected, a/c will not come on. You must use other buttons along with lowering the temprature setting selector for the a/c to kick in. 12 people found this helpful.
Why does the EC button not turn on?
“If you have a control unit where the EC button remains illuminated you most likely have a stored DTC code or a version coding error for refrigerant level sensor. In order for the compressor to be turned on DTC codes need to be cleared and the coding needs to be corrected.”
How does the reset work on an e320 Fixya?
The reset works as follows: With the key in the ignition and in posistion 2 push both the defrost button and the recirc button (at the same time) for five seconds or untill the led lights in those buttons begin to flash. Wait for 30 seconds or untill the led’s stop flashing. Switch off the ignition.
How to erase diagnostic trouble codes in Mercedes medic?
Proceed to ERASING DIAGNOSTIC TROUBLE CODES. 1) After display window shows “En° d”, press AUTO push button once again. Display window should show “dE L” (delete). 2) To erase DTCs, simultaneously press down and up arrow push buttons for more than 5 seconds.
How does the defrost button on a Mercedes work?
The defrost button has three lines going through it, while the recirculated air button has a picture of a car with a curved line through it. Hold these buttons down for about five to 10 seconds, or until the LED lights on both buttons start flashing. Wait 45 to 60 seconds for the LED lights to stop flashing. Then turn off the car.
The reset works as follows: With the key in the ignition and in posistion 2 push both the defrost button and the recirc button (at the same time) for five seconds or untill the led lights in those buttons begin to flash. Wait for 30 seconds or untill the led’s stop flashing. Switch off the ignition.
“If you have a control unit where the EC button remains illuminated you most likely have a stored DTC code or a version coding error for refrigerant level sensor. In order for the compressor to be turned on DTC codes need to be cleared and the coding needs to be corrected.”
How do you turn on the defrost on a Mercedes Benz?
Press recirculated air and defrost buttons on control panel together for longer than 5 seconds. The LED’s in the defrost and recirculated air buttons flash alternately. Wait until the LED’s stop flashing (approx 30 sec) system set to defrost LED on.