What does code u1111 and code u1073 mean?
These codes are both BUS related faults. The U1073 is indicating a communication problem with the engine ecu. The U1110/1 fault is usually the AC ecu end of the BUS not responding.
How do you read OBD codes on a Mitsubishi 96?
96 & later are OBD2 systems and require a scanner. Locate Data Link Connector (DLC), next to fuse box. Connect voltmeter positive lead to DLC terminal #1 and Negative lead to terminal #12 (ground). Turn Ignition switch to ON position. codes are read out by 12 volt pulses of voltmeter.
What are the trouble codes on a Mitsubishi?
Diagnostic trouble codes may be cleared by disconnecting the battery ground cable for at least 20 seconds. Reconnect negative battery cable and recheck codes to confirm the repair. Oxygen sensor fault. Airflow sensor fault. Intake air temp sensor fault. Throttle position sensor (TPS) fault. Idle speed control (ISC) motor position sensor fault.
When to use fault code p0011 on a Mitsubishi?
P0011 Code P0011 appears when the camshaft position is incorrect. There are no visible signs of the appearance of this error in the operation of the power unit, but the motor cannot work with optimal characteristics. Also, this code is accompanied by an increase in harmful substances in the exhaust gases. Possible causes of this error:
These codes are both BUS related faults. The U1073 is indicating a communication problem with the engine ecu. The U1110/1 fault is usually the AC ecu end of the BUS not responding.
What is the OBD code for u1073 engine?
U1073 engine code description to help fixing U1073 engine fault code properly.U1073 obd code details with dtc’s. Engine Code Search PUBC Search engine trouble codes. Example: P0120 U1073 Engine Fault Code Check Solution For U1073 OBD Code : U1073 engine code seems a kind of network problem, we try to show one by one the meaning and the solution.
Is there an A / C ECU time out for u1110?
Code No. U1110: A/C-ECU Time-out caution If Diagnosis Code U1110 is output from engine-ECU surely perform CAN bus line diagnosis. caution Replace ECU after certainly confirming that the communication circuits are normal.
96 & later are OBD2 systems and require a scanner. Locate Data Link Connector (DLC), next to fuse box. Connect voltmeter positive lead to DLC terminal #1 and Negative lead to terminal #12 (ground). Turn Ignition switch to ON position. codes are read out by 12 volt pulses of voltmeter.