What causes hot water heater reset button to trip?
The high resistance caused by a loose wire produces a substantial amount of heat that can eventually cause fires. If there is a loose electrical connection within your water heater’s system, your reset button’s thermometer can trip (regardless of the water’s temperature) if it picks up the heat from that loose wire.
How do I reset my whirlpool thermal switch?
Press the small reset button in the center of the thermal switch. If it’s tripped, you may be able to hear it click. Even if you do not hear the thermal switch click, try lighting the pilot using the instructions on the water heater’s label. If the Status Light now begins to flash, the thermal switch probably tripped.
Why does the reset button keep popping out?
If too much power is flowing through an outlet—say, because a device has fallen into water—the power is automatically cut off, and the RESET button pops out. Test monthly. d) The switches are called GFCIs: Ground Fault Circuit Interrupters.
How do you bypass a thermal switch?
The thermal fuse will look like a thin strip of white plastic with a wire coming out of each end. In order to bypass the thermal fuse, use electrical tape to tape the two ends together. The thermal fuse will then be bypassed. Turn the dryer on to a heat cycle for no more than 90 seconds.
What to do if your water heater thermal switch is tripped?
Press the small reset button in the center of the thermal switch. If it’s tripped, you may be able to hear it click. Even if you do not hear the thermal switch click, try lighting the pilot using the instructions on the water heater’s label.
Is there a way to reset the thermal switch?
To reduce the risk of property damage, serious injury or death, read and follow all labels on the water heater and the safety instructions in the printed owner’s manual. The thermal switch can trip if the water heater is not getting enough air. Press the small reset button in the center of the thermal switch.
Why does my gas water heater keep tripping?
Depending how its hooked up to chimmeny is to pull the flue and look inside.. Maybe some tiles fell down and is blocking it.. If you look at the top of the heater and the H/C grommets are melted that is a good indicator… It means its back drafting.. This can be deadly also as CO is enetering the home..