What causes an engine to start but not run?
An engine will start but not run when the fuel runs out . If the fuel pressure is not strong enough the car will stall out . Was this answer helpful? sailer342 , Stalling issues bad sensors TPS, MAP, MAF, IAC, O2, failing knock senor, faulty injectors, dirty throttle body, EGR valve, vacuum leak, failing fuel pump, etc.etc..
What causes a car to start and then die?
But if there is a fuel leak somewhere, then the proper amount of fuel won’t be able to make it to the combustion chamber. This might cause the engine to still start, but it won’t be able to keep it running. That is why it will die almost immediately after it starts.
What to do if your truck wont start?
To avoid throwing guesses and parts at your truck, have the truck scanned for trouble codes as a first step. Some of the auto parts suppliers offer free code reading like Pepboys, Nappa, Advanced auto parts,etc and some of the guys are very knowledgeable and may have seen the issue often and put you on the right track.
https://www.youtube.com/watch?v=kPnSa06tvqQ
An engine will start but not run when the fuel runs out . If the fuel pressure is not strong enough the car will stall out . Was this answer helpful? sailer342 , Stalling issues bad sensors TPS, MAP, MAF, IAC, O2, failing knock senor, faulty injectors, dirty throttle body, EGR valve, vacuum leak, failing fuel pump, etc.etc..
Why does my generator run for a few seconds then stops?
Low Fuel – Sometimes a very minor problem like less fuel in the fuel tank can also cause your generator to run for a few seconds and then stop. The generator may have enough fuel to get started a couple of times or run without the loads but when you out the loads, it stops.
What should the idle rate be on a 1997 GMC Truck?
Underdog, I don’t know the 1997 5.7, but 1000rpm sounds like a high idle, not where it should “bottom out”. A V8 should idle at 500rpm. GoNDown, did you recently disconnect your battery? After I left mine dead in the yard for a while and didn’t charge it, when I started it up it ran like you describe for a few days and then it was fine.
To avoid throwing guesses and parts at your truck, have the truck scanned for trouble codes as a first step. Some of the auto parts suppliers offer free code reading like Pepboys, Nappa, Advanced auto parts,etc and some of the guys are very knowledgeable and may have seen the issue often and put you on the right track.
https://www.youtube.com/watch?v=-bgZXG77yAM