What causes a Jeep Liberty to stall?
If your Jeep Liberty shuts off while driving you could have a faulty CPS (Crankshaft Position Sensor) circuit. It could also be a faulty camshaft sensor or faulty IAC valve. Do a thorough inspection of the wiring for shorted out wires, burnt wires or faulty connections. The problem in many cases is the sensor circuit.
Where is the starter on my Jeep Liberty?
The starter is located on the driver’s side of the engine midway between the oil pan and the intake manifold bolted to the bellhousing.
- Lift the hood and check the battery terminal connections for cracking, looseness or corrosion.
- Check the battery cable to the starter solenoid.
Why is my Jeep Liberty in no crank condition?
No clicking from solenoid or attempt to do anything. 1. Battery has been ruled out. Swapped battery from my car and condition is the same. 2. Cables are good. 3. BCM is good. Lights, Horn, Radio, Key Fob. etc etc working normally. 4. Tried Neutral safety switch by moving through from Park to Neutral while turning ignition – No change.
Why is my Jeep Liberty stalling and stalling?
Anyway, got it towed to the garage again, this time they said it needed two what they called Transmission sensors. They replaced them free of charge. Took it out drove it around town for about 20 mins then it starts acting up again just driving down the road doing about 35 MPH. same symptoms.
What’s the problem with my 2002 Jeep Liberty?
After about three years of little problems with my 2002 Liberty, I now have a big one. At about 38,500 mile (out of warranty of course) the engine start dieing. I took it to my dealer and they replaced the Crank Sensor.
What happens if the starter on a Jeep Liberty is fried?
If the starter is being fried, then the starter has been placed in a postion as a “fusable link”. I venture to say that much of the Liberty’s wiring has been put under tremendous strain from over-voltage, that even if its fixed, then unsafe situations in the wire’s integrity are almost guaranteed.
What makes a Jeep Liberty not to start?
Car starts when engine is cold, but only cranks, no fire once it has been started until the following morning. Also, no heat, only blows cold. This all happens at the same time. Took it to mechanic last week, they said needed I new computer.
When was the last time a Jeep Liberty had a crank condition?
This topic contains 27 replies, has 8 voices, and was last updated by dreamer2355 9 years, 1 month ago. Hi everyone, Newb here with his 1st post.
Are there skim keys on a Jeep Liberty?
One interesting thing is that the Security LED on the dash is lit during all of this. Also, the Jeep doesn’t use the SKIM system for the keys/ignition. Mine are just the normal black (Non SKIM) keys, One interesting thing is that the Security LED on the dash is lit during all of this.