What causes a carburetor to come off a Kawasaki lawn mower?
It doesn’t take much to get an engine to run erratically. One would think that less than 30 minutes would be enough to cause an intake valve with insufficient gap to heat up enough to come off its seat. Wouldn’t hurt to go through the carburetor and give a good cleaning with carburetor cleaner and re-assemble.
Why are my carburetors not working on my motorcycle?
Fixing Lean Mixtures. This condition is generally caused by the incorrect fitting of after-market accessories such as exhaust systems, air filter systems, or replacement carburetors of a different type or size. In addition, if the fuel level in the float chamber is set too low, insufficient fuel will be drawn through the main jet.
Where can I buy a Kawasaki carburetor rebuild kit?
Kawasaki Carburetor Rebuild Kits, Kawasaki Carburetor Parts, Kawasaki Carburetors, Kawasaki Accessories & Tools available from a wide range of online sources collected all in one spot. Check-out the wide selection and discount prices.
Why do I have a problem with my Kawasaki bike?
Most owner reports say that it happened between gears 4,5 and 6 and that the problem occurs intermittently and is hard to replicate. This happens on any bike due to the force generated by the free-spinning flywheel after disengaging the clutch.
It doesn’t take much to get an engine to run erratically. One would think that less than 30 minutes would be enough to cause an intake valve with insufficient gap to heat up enough to come off its seat. Wouldn’t hurt to go through the carburetor and give a good cleaning with carburetor cleaner and re-assemble.
How do you adjust the carburetor on a Kawasaki?
Adjust the high-range screw by a half turn, spinning it counterclockwise. Restart the motorcycle engine and pull back on the throttle again to raise the speed. Examine the engine sound and adjust the high-range screw by one-quarter turns, taking note of how the engine sounds each time.
When to stop adjusting the carburetor on a Kawasaki MULE?
Stop adjusting when the engine idles at a speed somewhere between 850 and 950 RPM. There are two brass mixture screws located at the top of the carburetor, one for each cylinder of the engine. Give them a few turns and return them to their original position to keep them from corroding in place.
What should I do if my carburetor is not working?
Turning this screw clockwise will reduce the amount of air entering the carburetor, and will, therefore, richen the mixture (refer to a shop manual for correct settings).
What should I do if my Kawasaki Idles dies?
If it has been sitting a while the carb is plugged up. You have to pull it completely apart to clean it. Get a bucket of parts cleaner and soak your carb over night. Pull it out and blow compressed air through it. Find out where the air is coming out of and put your finger over that hole. Repeat that a few times (blowing the carb out).
Why does my Kawasaki ATV die when I hit the throttle?
If it will only run with full choke on your carb is still plugged up somewhere. By just putting new jets in it wont do a dame thing. If it has been sitting a while the carb is plugged up.
How long does a Kawasaki lawn mower run before it dies?
It runs great when the blades are not engauged but when i engauge the blades it runs great for 30 minutes then it dies. It restarts and I run it for a few second then dies.