What can cause P0335?
P0335 can have a variety of causes such as: Open or short in the wiring harness. Poor electrical connections. Crankshaft position sensor failure.
What are the possible causes of a p0335 Nissan?
P0335 NISSAN Possible Causes 1 Faulty crankshaft position sensor 2 Crankshaft position sensor harness is open or shorted 3 Crankshaft position sensor circuit poor electrical connection 4 Signal plate may be damage 5 Starter motor may be faulty 6 Starting system circuit 7 Dead or weak battery
What causes a faulty crankshaft position sensor on a Nissan?
P0335 NISSAN Possible Causes Faulty crankshaft position sensor Crankshaft position sensor harness is open or shorted Crankshaft position sensor circuit poor electrical connection Signal plate may be damage Starter motor may be faulty Starting system circuit Dead or weak battery
Why do I have a p0335 code on my battery?
Sometimes and in some models, low battery voltage or a weak starter can trigger a Crankshaft Position Sensor code. Before replacing any parts, recharge or replace the battery.
What is the crankshaft sensor on a Nissan Altima?
Nissan Altima P0335: Crankshaft Position Sensor “A” Circuit Malfunction. The Nissan Altima utilizes a crankshaft position sensor in order to regulate the engine timing. This sensor uses a reluctor to gauge the position of the crank.
P0335 NISSAN Possible Causes 1 Faulty crankshaft position sensor 2 Crankshaft position sensor harness is open or shorted 3 Crankshaft position sensor circuit poor electrical connection 4 Signal plate may be damage 5 Starter motor may be faulty 6 Starting system circuit 7 Dead or weak battery
When does the p0335 crankshaft position sensor a circuit?
If the PCM detects that there are no crankshaft pulses or if it sees a problem with the pulses on the output circuit, P0335 Nissan will set. NOTE: If the crank sensor is used only for misfire detection and NOT spark timing (this varies with the vehicle), the vehicle should start and run with MIL (Malfunction indicator lamp) illumination.
P0335 NISSAN Possible Causes Faulty crankshaft position sensor Crankshaft position sensor harness is open or shorted Crankshaft position sensor circuit poor electrical connection Signal plate may be damage Starter motor may be faulty Starting system circuit Dead or weak battery
When does the ECM set the trouble code p0335?
It works hand in hand with the reluctor ring that creates a square wave voltage signal that the ECM interprets as the crankshaft position. Trouble code P0335 is set whenever the ECM does not sense crankshaft pulses or senses a problem with the pulses in the output with Sensor “A” Bank 1.