Is the 3800 Series 3 a good engine?
The 3800 is a great engine, powerful, reliable.
Is the 3800 V6 a good engine?
It is also by far the most popular of the 3800 family for its power, smoothness, fuel efficiency, and reliability, although the stroke for the 3.8 liter engine remained at 3.4 in (86 mm), and the bore remained at 3.8 in (97 mm). The 3800 Series II was on the Ward’s 10 Best Engines list for 1995 through 1997.
How much horsepower does a 3800 V6 have?
The supercharged 3800 Series III, found in the Grand Prix GT or GTP (depending on model year), unleashed 260 horsepower. The 3800 and 3800 SC Supercharged engines offered 230 foot-pounds of torque at 4,000 RPM and 380 foot-pounds of torque at 5,200 RPM, respectively.
What was the last year for the 3800 engine?
1988-2003: The 3800 becomes GM’s workhorse engine. The engine grew to 225 cubic inches in 1964. Production stopped in 1967, and GM sold engine and production tooling to the Kaiser-Jeep Corp., the company that owned the Jeep brand.
How long does a 3800 engine last?
A basically solid engine encumbered with various parts designed to fail. Oh, and to answer the original question: 70,000 miles.
How many miles will a 3.8 last?
If its Mopar, it will last. They last 28,623 miles.
How reliable is the 3800 engine?
The’re pretty reliable. I’ve had a few with intake gasket issues, and on the newer ones with the plastic intake manifolds I’ve had cases where the manifold itself was damaged. Also had a few with cracked EGR tubes, and most of them leak oil. The motor itself is pretty bullet proof though.
Can I put a supercharger on my 3800?
One of the most common questions in the 3800 market is “Can I bolt a GTP supercharger onto my GT (L36) engine. The short answer is no. The only things the non supercharged and supercharged 3800’s have in common are the block and crank. Everything else is different.
What cars had 3800 engines?
The GM 3800, 3.8-liter V-6 came in the Chevrolet Monte Carlo, Malibu, El Camino, Impala, Monza, Caprice, Camaro and Lumina. Chevrolet replaced the Buick version with another 3.8-liter V-6 version, based on the Chevrolet 305 V-8, from 1980 to 1985.
When did the 3800 Series 3 come out?
In 2005, it was the first gasoline engine in the industry to attain SULEV (Super Ultra Low Emissions Vehicle). Also note that Series III engines are the base for any 3800 produced for the 2004 year and up. This means the same block, heads, & connecting rods apply to any remaining Series II engines made after 2004 also.
What kind of horsepower does a 3800 Series 2 have?
The 3800 Series II was very reliable. CXS engine may have less displacement but it delivers 240 hp @ 6000 rpm and 225 lbs-ft of torque at 2000 rpm. Much higher rpms than the SC 3800 Series II on hp but max. torque much earlier. I noticed the final drive axle ratio has been bumped up to 3.69.
When did the Buick 3800 Series 2 come out?
The 3800 Series II was on the Ward’s 10 Best Engines list for 1995 through 1997. A 3800 Series II L67 Supercharged engine in a 1998 Buick Regal GS.The L67 is the supercharged version of the Series II L36 and appeared in 1996, one year after the normally-aspirated version.
What’s the difference between the L26 and the 3800?
This means the same block, heads, & connecting rods apply to any remaining Series II engines made after 2004 also. The difference is that Series III engines received the new superchargers (if equipped), intake manifolds, fuel systems, and electronics. The L26 is the Series III version of the 3800. It is still a 3.8 L design.