Is it illegal to sell a car with the check engine light on?
You can sell your car with the check engine light on, but you won’t get as much for it. You can sell your vehicle in any condition as long as it is your’s legally.
How do you reset the computer on a Subaru Forester?
How to Reset a Subaru Check Engine Light
- Open the hood of your Subaru and loosen the nut that holds the cable clamp to the negative battery terminal.
- Slide the cable off the negative battery terminal.
- Wait 5 minutes, then reconnect the cable and tighten the retaining nut.
What are the codes for Subaru check engine light codes?
P1086Tumble Generator Valve #2 (LH) Position Sensor Circuit Low Input P1087Tumble Generator Valve #2 (LH) Position Sensor Circuit High Input P1088Tumble Generator Valve #1 (RH) Position Sensor Circuit Low Input P1089Tumble Generator Valve #1 (RH) Position Sensor Circuit High Input P1090Tumble Generator Valve #1 (RH) Malfunction (Stuck Open)
Where do you find the trouble code on a Subaru Justy?
The long segment (1.2 sec on) indicates a “ten”, and the short segment (0.2 sec on) signifies a “one”. 90 models – Trouble codes on the Justy are viewed on the Oxygen Moniter light, all other models the codes can be viewed on either the Oxygen Moniter light or the MIL (check engine light).
Why does my Subaru check engine light keep showing up?
Subaru check engine light shows up if there is an issue with the Subaru computer emissions control system. Then the Subaru’s computer which is usually called ECU will produce error codes that relate specifically to the particular sensor affected in the car. If anyone of these sensors fails, it will prompt a fault or an error code.
What is the OBD code for a Subaru Impreza?
Manifold vacuum sensor or circuit/coolant temperature sensor or circuit on 1984 models)/float chamber vent solenoid valve or circuit (1983 to 1985) Fuel injector no. 2 (Legacy, Impreza, Justy, SVX); Fuel injector 3 and 4 (Loyale, GL, DL); Fuel injector 5 and 6 (XT6)