How to troubleshoot Eaton 10 speed transmission issues?
Nefi Thanks this. Here’s a link to every Eaton transmission service manual you would ever need. There is troubleshooting instructions for different symptoms in them, including air system problems. Sounds like worst case scenario you have to pull the top plate to get to the splitter. Super_Trucker, Nefi and BoxCarKidd Thank this.
What causes transmission to walk apart in Eaton Fuller?
Tapered or worn clutching teeth will try to “walk” apart as the gears rotate. Under the right conditions, slipout will result. Some of these conditions are: Transmission mounted eccentrically with engine flywheel pilot. Excessive gear clashing which shortens clutching teeth.
What’s the service code on an Eaton 3 pedal?
158 satisfied customers Fuller Eaton 3 pedal Auto Shift. locks in 9th gear 2003 Sterling with Detroit and fuller Eaton 3 pedal Auto Shift. Has started last week hanging in 9th gear with service light flashing. Same in auto, or manual mode. Code 51 flashing.
What is the transmission code on an Eaton?
It is a RTO-16710C-AS2. 16 code for transmission is eaton proprietary link failure and code 43 on transmission side is a range valve failure. Sounds to me like a range valve problem.
Where does the air pressure go in an Eaton Fuller?
When the range selector on the shift knob is moved down to select low range, air pressure will flow through the shift knob to the “P” port on the slave valve. The slave valve will direct air pressure through the low range 1/4″ rubber hose to the range cylinder to shift the range.
Where is the Air Line in an Eaton transmission?
At the rear of the transmission, disconnect the 1/4″ rubber air line from the low range supply port on the range cylinder. Check for air flow from the low range port. Air flows from the low range port. Remove range cylinder cover and repair leaking range piston or piston seal.
What causes a burst of air in an Eaton transmission?
A burst of air will be exhausted from the shift knob when moving the range selector from low to high. This is the air being exhausted from the “P” air line. A burst of air will be exhausted from the shift knob when moving the splitter button rearward (shifting to low split). This is the air being exhausted from the “SP” air line.
Why does my Eaton Fuller not shift gears?
My eaton fuller autoshift suddenly will not go into any gears in my driveway, just shows down arrows and R or 2 (flashing) when I try to go into any gear. When i have the truck off and turn key to start position and try to shift gears i can hear the transmission shifting successfully, however once the engine is running it will not shift gears.
Why does my Eaton transmission make a lot of noise?
There will always be a certain level of noise due to the normal transmission operation. However, excessive noise or unusual noise such as a whine, growl, or squeal indicates some kind of a problem. The transmission itself can be the cause of excessive or unusual noise.
Why does Autoshift not go into any gears?
When i have the truck off and turn key to start position and try to shift gears i can hear the transmission shifting successfully, however once the engine is running it will not shift gears. There are no service lights or error codes being displayed.