How to troubleshoot a C13 engine injector?
Inspect the Wiring Harness Between the ECM and the Valve Cover Base A. Turn the keyswitch to the OFF position. B. Thoroughly inspect the connectors. Refer to Troubleshooting, “Electrical Connectors – Inspect” for details. 45 N (10 lb) pull test on each of the wires in the ECM connector.
What is the wiring diagram for a caterpillar?
Cat c15 Ecm Wiring Diagram . Ecm Wiring Diagram Heisto PDF or Read Cat C15 Engine Ecm Wiring Attracktive Caterpillar C12 Wiring Diagram Cat Pin Ecm Wiring. Sun, 04 Nov GMT caterpillar c12 ecm wiring diagram pdf – OK If the Personality Module has been recently replaced/updated. OK. Observe.
Why is Cat C13 ACERT diesel engine optimized?
Fuel consumption optimized to match operating cycles of a wide range of equipment and applications while maintaining low operating costs.
Is there a Cat et test for injector solenoids?
The wiring and/or the connectors may have problems that only occur during vibration. Cat ET includes the following test that aids in troubleshooting injector solenoids: Injector Solenoid Test – The Injector Solenoid Test identifies an open circuit or a short circuit in the circuits for the injector solenoids.
Are there any problems with the cat C15 engine?
After changinging fuel filters with no result we put it in shop and found #1 and #2 injectors bad.
When does an injector short circuit in an engine?
However, the ECM will periodically try to fire the injector. If the short circuit remains, this sequence of events will be repeated until the problem is corrected. Typically, problems with an injector solenoid occur when the engine is warmed up and/or when the engine is under vibration (heavy loads).
Why did my C-15 twin turbo engine go bad?
Had an ecm go bad on our 2005 C-15 Twin turbo, cost was about $2100 to replace at dealer and take a look at fuel line that runs behind ECM they will rub computer from vibration and chafe the line and leak, Put some insulation on it after repair.