How to test my start button on Harley davidson?
Unplug the connector and probe it for B+ while pushing the start button. If it shows volts the start button is good. Then take a jumper wire from the battery positive terminal to that same connector plug on the starter, the starter should spin and engage the engine (crank over).
Why wont my Harley start?
If the engine doesn’t crank, it could be because of a failure at any of those stages, a weak battery, or a bad starter. If the motor cranks and still won’t start, then it is likely a fuel or spark issue. A few tests can be performed to quickly track down the problem.
Where to check for no start fuel pump?
The first thing you want to do is check the fuse panel to see if the fuse is blown. If your car has two fuse panels than the one in the engine compartment; should be the correct one to check. The fuse panel or circuit box is usually located near the battery; and is a small black box with a removable lid.
Why does my Harley Davidson have no fuel pump?
If battery static volts measure 11.6v or less with the ignition on the ECM won’t energize the system. am not getting any voltage at the 15 amp fuse at key on, also have battery charger on while testing. engine cranks at good speed. are there more powers and grounds at the battery then just the main positive and negative battery cables?
Why does my fuel pump run hot when I shut off the engine?
This is due to the fact that when you shut off the engine with a low fuel level; the fuel can drain from the priming chamber designed into the fuel delivery system. So when you restart your car, the pump runs hot and un-primed until it can refill the fuel chamber. Over time this will burn out the pump motor.
What causes a fuel pump to die before filling up?
If you make a habit of running your tank all the way to empty before filling up; your fuel pump will most likely die before its designed lifespan. This is due to the fact that when you shut off the engine with a low fuel level; the fuel can drain from the priming chamber designed into the fuel delivery system.
The first thing you want to do is check the fuse panel to see if the fuse is blown. If your car has two fuse panels than the one in the engine compartment; should be the correct one to check. The fuse panel or circuit box is usually located near the battery; and is a small black box with a removable lid.
If battery static volts measure 11.6v or less with the ignition on the ECM won’t energize the system. am not getting any voltage at the 15 amp fuse at key on, also have battery charger on while testing. engine cranks at good speed. are there more powers and grounds at the battery then just the main positive and negative battery cables?
This is due to the fact that when you shut off the engine with a low fuel level; the fuel can drain from the priming chamber designed into the fuel delivery system. So when you restart your car, the pump runs hot and un-primed until it can refill the fuel chamber. Over time this will burn out the pump motor.
If you make a habit of running your tank all the way to empty before filling up; your fuel pump will most likely die before its designed lifespan. This is due to the fact that when you shut off the engine with a low fuel level; the fuel can drain from the priming chamber designed into the fuel delivery system.