How to take a position on hydraulic cylinder sensors?
Taking a Position on Hydraulic Cylinder Sensors No clear-cut choices exist when it comes to selecting a linear displacement transducer for position feedback of hydraulic cylinder position. However, this comparison of the most common technologies may help narrow down the field.
Is there a CPI cylinder position sensor for pneumatic cylinders?
Hydraulic Cylinder Position Sensor Installation Is a Snap. Hydraulic cylinder position sensors from CPI eliminate the need for a hollow cylinder rod and allow for precision position sensing electronics in a single actuator. They are superb for end-of-stroke detection on both hydraulic and pneumatic cylinders.
What kind of sensors are used on cylinders?
Populating these cylinders are position feedback sensors, which employ one of three traditional technologies: magnetostrictive, variable resistance, and variable inductance sensors. Other sensor technologies have seen some success in this application, but the focus of this article is to compare these three most popular technologies.
How does an inductance sensor on a cylinder work?
Inductance sensors operate by measuring the resonant frequency of an oscillator circuit that uses an inductive probe whose inductance is varied by the position of the gun-drilled rod over it.
How does a pneumatic cylinder position sensor work?
View Tameson’s range of pneumatic cylinder position sensors. Our reed sensors (magnetic proximity sensors) detect the magnetic field of a magnet that is integrated in the cylinder piston to determine the linear position of the piston. They will… Read more View Tameson’s range of pneumatic cylinder position sensors.
What kind of sensor is used for cylinder stroke?
Linear position sensors provide accurate, non-contact position sensing anywhere along the cylinder stroke for a wide variety of applications. Hydraulic/Pneumatic sensor housing with integral electronics.
Can a CPI sensor be installed on a hydraulic cylinder?
CPI’s Hydraulic Cylinder Position Sensors install into standard hydraulic cylinders with minimal modifications and are suitable for field retrofit where rod-type sensors have failed.
How are sensors mounted on a round cylinder?
Round cylinders are generally smaller, like ISO 6432, but sensors can still be mounted to them by using a circular band to go around the cylinder’s housing. The band needs to be specified in accordance with the cylinder’s diameter. Once mounted, the sensor and band can slide along the length of the cylinder and then fastened into place.