How to reset the maint reqd light in Toyota?
How to Reset the Maint Reqd Light 1 Turn the key to the on position with the odometer showing. 2 Press and hold the odometer button. 3 Turn the key to the off position while still holding the odometer button. 4 Without releasing the odometer button, turn the key to the run position. 5 Wait a few seconds for the light to turn off.
How to reset the ” maintenance required ” light in my Lexus?
Lexus takes us through the steps in resetting that Maintenance Required Light that pops up on the Instrument Panel. Remember, this procedure should be used to reset the light when maintenance has been performed
How to reset the maint count on a Lexmark?
Release the buttons when you see Performing Self Testor a stopwatch symbol on the display. A new menu should appear with CONFIG MENUat the top of the screen. 2 Press the button once. The checkmark on the left should now be in front of Reset Maint Cnt(or Reset Maint Count). 3 Press the button once.
How to clear the 80 scheduled maintenance message?
Resetting the maintenance counter to zero After the maintenance kit parts have been replaced, the maintenance count must be reset to zero to clear the 80 Scheduled Maintenancemessage. Follow the instructions in the table below. IMPORTANT! Do not reset the maintenance count until AFTERyou have had the maintenance kit parts replaced.
How do I reset the maintance light?
Here’s how you do a maintenance light reset: Put your key in the ignition. Turn the key to position one. This is the position just before starting the car. Push the trip meter reset button on the dashboard. Hold it down for a second or two. Continue to hold the odometer button for around ten seconds. The light should flash, beep, and then go out. Once off, release the odometer button. Start your car.
How do I reset maintenance light?
Turn your vehicle’s ignition to the “acc” setting while holding the button. Do not crank the vehicle. Hold the position for five seconds and turn the ignition key off. Release the button. The maintenance light will be reset and will illuminate again the next time service is due.
How do you turn off the maintenance required light on a Toyota Sienna?
Turn your ignition key to the ‘ACC’ or ‘LOCK’ position. Press and hold the trip meter reset nob (next to your Toyota Sienna’s odometer). While holding the trip meter reset nob, turn the ignition to ‘ON’, but do not start your Toyota Sienna. Hold the meter reset until the MAINT REQD light switches off.