How to Program key fob 2006 pontiac montana sv6?
PUSH and HOLD the LOCK and UNLOCK button for 1.5 seconds on the first remote being programmed. As soon as you let go PUSH the LOCK button and HOLD it for 2 seconds. 13. The door locks will cycle to confirm successful programming of the remote.
How to Program key fob 2005 pontiac montana sv6?
2005 Pontiac Montana Remote Programming
- Remove key from ignition.
- Remove the MALL PGM or BCM PRGRM fuse from fuse box (you only need to remove one fuse on this step.
- Close all doors.
- Turn ignition switch to ACC.
- Within 1 second turn the ignition to OFF then back to ACC. (
- Open then close the driver’s door.
How do you program a 2005 Pontiac Montana?
Enter your 2005 Pontiac Montana with all of your remotes. This is important because all of the remotes will erase once you enter programming mode. Put your key in the ignition and remove it. Using the legend on the fuse panel as your guide, remove the “BCM PRGRM” fuse. You can access the fuse panel by opening the front passenger door.
Is the Pontiac Montana SV6 a registered trademark?
GENERAL MOTORS, GM, the GM Emblem, PONTIAC, the PONTIAC Emblem, and the names MONTANA and SV6 are registered trademarks of General Motors Corporation. This manual includes the latest information at the time it was printed. We reserve the right to make changes after that time without further notice.
How do you program a 2005 Pontiac Vibe?
A chime will sound three times to let you know that you are in programming mode. Press both the “lock” and “unlock” buttons on the remote for about 30 seconds. A chime will sound twice if the remote has been programmed successfully. To exit the programming mode, simply remove the key from the ignition. Enter your 2005 Pontiac Vibe.
What do I need to program my Pontiac key fob?
Domestic automakers usually include instructions with your owner’s manual about how to program your key fob. Pontiac does include programing instructions for the Aztek, Vibe, and Montana, but not for the Bonneville, G6, Grand Am, Grand Prix, Montana SV6 or Sunfire models.
Enter your 2005 Pontiac Montana with all of your remotes. This is important because all of the remotes will erase once you enter programming mode. Put your key in the ignition and remove it. Using the legend on the fuse panel as your guide, remove the “BCM PRGRM” fuse. You can access the fuse panel by opening the front passenger door.
GENERAL MOTORS, GM, the GM Emblem, PONTIAC, the PONTIAC Emblem, and the names MONTANA and SV6 are registered trademarks of General Motors Corporation. This manual includes the latest information at the time it was printed. We reserve the right to make changes after that time without further notice.
A chime will sound three times to let you know that you are in programming mode. Press both the “lock” and “unlock” buttons on the remote for about 30 seconds. A chime will sound twice if the remote has been programmed successfully. To exit the programming mode, simply remove the key from the ignition. Enter your 2005 Pontiac Vibe.
How do you programming a 2005 Pontiac Aztek?
Enter your 2005 Pontiac Aztek. Close all doors. Press and hold the “unlock” button on the driver’s door. While holding the door lock, insert the key twice without turning it. Insert it a third time and leave the key in the ignition. Release the door lock. A chime will sound three times to let you know that you are in programming mode.