How to fix a Pontiac Montana SV6 brake problem?
Replaced front hubs, and rotors and brakepads, rear hubs and brake pas. Complete brake bleading as ABS brake bleeding instructions. Still ABS light, stability control on. Not successfull in getting lights to go off and still no ABS Replaced the wiring connector behind driver seat in the floor, infront of passenger. The conectors were all rusted.
Is there an extended warranty on a Montana SV6?
An extended warranty can provide peace of mind. Chart based on 15 repair trips. The repair cost chart excludes repairs made under warranty, do-it-yourself repairs, and repair trips that include maintenance. Brake cable system was broken and had to be replaced.
What are the names of the Pontiac warning lights?
Click a link to learn more about each one. They are roughly ordered by importance, which tends to be by color (red, amber, yellow, orange, green, blue). There are over 40 of them, so search carefully! Models examined include G3, G5, G6, G8, Grand Prix, Solstice, Torrent, and Vibe.
What kind of engine does the Montana SV6 have?
The second generation Pontiac Montana was renamed Pontiac Montana SV6 and was fitted with a 3.5 liter high value V6 engine that generated 200 horsepower. If you are encountering Pontiac Montana SV6 problems and require technical assistance you should seek professional help.
What causes a Pontiac Montana SV6 to overheat?
When the blower motor bearings start to go bad then the blower motor will pull too many amps which causes the wires to overheat. To fix this issue you need to replace the blower motor and the wire harness will need to be repaired. You will also need to replace the switch, pig tail, the plug, and a small section of the wire.
How to reprogram a Pontiac Montana SV6 key?
To reprogram your new key you need to bump the key in the start position and then leave it in the on position for 10 minutes and then switch it off for five seconds you need to repeat this procedure twice and then start the vehicle. What is causing my Pontiac Montana SV6 to squeak and why is the transmission not engaging right away?
Replaced front hubs, and rotors and brakepads, rear hubs and brake pas. Complete brake bleading as ABS brake bleeding instructions. Still ABS light, stability control on. Not successfull in getting lights to go off and still no ABS Replaced the wiring connector behind driver seat in the floor, infront of passenger. The conectors were all rusted.
Why are there electrical issues in my Pontiac Montana?
The GM supplier used a plastic connector that would not withstand the heat, so it started to melt, and the black power wire shorted out other wires. It can also cause electrical feedback problems with ABS and Traction Control System false error warnings.
Why does my Pontiac Montana horn blow when I hit the brakes?
2000 Montana, when I hit the brakes the horn blows. Is it possible that these wires are somewhere connected? Hi, I have a 2000 Pontiac Montana with the same problem. My interior light comes on when I turn on the rear defrost, brake lights or turn signals. They stay on until I use the overide switch.
Why is my brake light not working on my Pontiac Montana?
It was a short in the rear light connector for the brake light / tail light / turn signal fixture. The GM supplier used a plastic connector that would not withstand the heat, so it started to melt, and the black power wire shorted out other wires.