How often do you change bypass oil filter?
With a bypass system, you would go 25,000 miles, change the bypass filters and take an oil sample; the results would dictate if you needed to change your oil. Using that system, most newer engines are able to go 150,000 to 200,000 miles without an oil change.
How big does an AMSOIL bypass filter need to be?
The average full-flow oil filter, however, is only efficient for particles 20 microns and larger. This means particles under 20 microns can pass though the filter and cause engine wear. An AMSOIL bypass system filters particles down to 2 microns, effectively reducing engine wear. Here’s how to install an AMSOIL bypass system.
Can a bypass system be installed on an AMSOIL truck?
The following AMSOIL bypass system is recommended for this vehicle: The system draws oil from the full-flow oil filter location and returns it through the filler neck. While the oil is draining, identify a good location on the truck to mount the filter head onto which the bypass filter threads.
Can a bypass filter be prefilled with oil?
Once the head is mounted, thread on the bypass filter. If possible, fill the filter with motor oil first. Horizontally mounted filters may not allow for prefilling with oil. Using a dab of clean oil, lubricate the filter gasket. Spin it on and tighten it per the instructions on the label.
How do you install a bypass filter on a car?
Adding the bypass filter and hoses will increase the system’s capacity. For now, however, add the recommended volume of oil for the vehicle. Start the vehicle. While it’s running, check the hose fittings and other components for leaks. Once you’re satisfied there are no leaks, shut off the engine and let it sit a few minutes.
The average full-flow oil filter, however, is only efficient for particles 20 microns and larger. This means particles under 20 microns can pass though the filter and cause engine wear. An AMSOIL bypass system filters particles down to 2 microns, effectively reducing engine wear. Here’s how to install an AMSOIL bypass system.
The following AMSOIL bypass system is recommended for this vehicle: The system draws oil from the full-flow oil filter location and returns it through the filler neck. While the oil is draining, identify a good location on the truck to mount the filter head onto which the bypass filter threads.
Once the head is mounted, thread on the bypass filter. If possible, fill the filter with motor oil first. Horizontally mounted filters may not allow for prefilling with oil. Using a dab of clean oil, lubricate the filter gasket. Spin it on and tighten it per the instructions on the label.
Adding the bypass filter and hoses will increase the system’s capacity. For now, however, add the recommended volume of oil for the vehicle. Start the vehicle. While it’s running, check the hose fittings and other components for leaks. Once you’re satisfied there are no leaks, shut off the engine and let it sit a few minutes.