How much does it cost to change a stator?
Stator & Rotor A new stator and rotor set typically costs between $250 and $1,500.
How much voltage does a stator produce?
For example a 32-amp stator should put out 18 volts AC (VAC) per each 1000-RPM. At 2000 it should be 36 VAC (18×2). At 3000 RPM it should be 54 VAC (18 X 3).
How much does it cost to get a new stator?
Create a Battery-op Ignition System for Less Than $50 The cost of a new stator can be hundreds of dollars. Without a good stator, your engine will run poorly or not at all. This solution completely bypasses the stator by using a 12 volt battery to power the ignition system.
What should the voltage be for a stator Charger?
A good rule of thumb is you can convert to power by multiplying the stator amps ( current) x the battery ( voltage ). You can use 13 as a good all around battery voltage. That is a good healthy battery staying charged just above 12 volts. Example only: Let’s say the stator is rated for 10 amps x 13-volt battery: 10 x 13=130 watt charging system.
Do you need a core exchange for a stator rebuild?
Rick’s manufacturers new and rebuilds custom stators for motorcycles, ATVs, UTVs, off road, street bikes, & snowmobiles. All rebuilt stators require a core exchange and come with a one year replacement warranty.
Is there a warranty on a rebuilt stator?
All rebuilt stators require a core exchange and come with a one year replacement warranty. Most new and rebuilt stators are built to stock specification, but we do offer some high output stator versions as part of the Hot Shot Series so you can get even more electrical power from your machine.
Create a Battery-op Ignition System for Less Than $50 The cost of a new stator can be hundreds of dollars. Without a good stator, your engine will run poorly or not at all. This solution completely bypasses the stator by using a 12 volt battery to power the ignition system.
How can I tell if my stator needs to be replaced?
This test makes sure that the stator isn’t shorting out to the ground. Your meter should read “OL” or open line. If the multimeter is picking up a reading, it means your stator needs to be replaced. Repeat this test for each of the windings.
Where do you put the wire for a new stator?
The wire marked red (coming from the engine) in the diagram is going to attach directly to the contact breaker points. There should already be a wire connected to the breaker points right where we need to put the new one. You need to remove that old wire and put the wire for the new system RIGHT WHERE THE OLD ONE WAS.
What to do if your stator on your ATV is bad?
This is a free and easy fix so try it out if your battery is still good. Voltage regulator rectifier unit: If your voltage regulator is bad, you’ll have the same problems as if your stator is bad. This can make it difficult to determine, which is the problem. You can test this with a multimeter to see if it is working.