How many quarts does an empty 4L60E hold?
A 4L60E will take 4-6 quarts on a fluid and filter change.
How many quarts of transmission fluid does a 42RLE take?
Your 42RLE is very fussy about its ATF, it must be ATF+4. It cannot be some generic or “super” ATF claiming to be compatible with ATF+4, it must actually say ATF+4 in big letters on the front label of the bottle. For a simple pan drop and filter change, you’ll need about 4 quarts.
How do you drain the transmission fluid on a 4L60E?
Removal Procedure
- Locate the upper transmission line on the passenger side and remove the line from your vehicle’s radiator.
- Once the line is removed, connect your brass trans cooler line fitting.
- Route the tubing to your catch pan or bucket.
- Now you will begin to flush the fluid.
How much transmission fluid does a 4L60e take?
The fluid capacity of the 4L60e is 12 quarts of transmission fluid (dry). This amount is based on a stock, “shallow” transmission pan with a 12″ torque converter.
What type of transmission fluid does a 1994 Chevy Silverado take?
Valvoline Synthetic Transmission Fluid Dexron VI 1 Quart.
How much transmission fluid does a Jeep Liberty need?
Fluid Capacities and Type
| Capacity (Quarts) | Capacity (Liters) | |
|---|---|---|
| (5)45RFE Transmission (Service) | 5.00 QUARTS | 4.73 LITERS |
| 42RLE Transmission (Dry Fill) | 8.80 QUARTS | 8.30 LITERS |
| 42RLE Transmission (Service) | 4.00 QUARTS | 3.80 LITERS |
| NSG370 Manual Transmission | 1.585 QUARTS | 1.50 LITERS |
How many quarts of fluid to fill 4L60E at service?
The 4L60e’s fluid volume is 12 quarts (dry) of transmission fluid. This volume is based on a stock, with a 12 “torque converter,” shallow “transmission pan.” The ability of additional fluid will range from an extra quart or more with a deep pan.
What are some common problems with the 4L60E transmission?
Three of the most common problems found in a GM 4L60E transmission are: 3 – 4 Clutch Pack Failure Broken Drive Shell Worn TCC Regulator Valve
Is a 4L60E interchangeable with a 4L80E?
FYI – 4L60E & 4L80E transmissions are NOT directly interchangeable. The wiring pinout of the trans plug is different, and 2 VSS’s are used versus 1 on the 4L60E. Besides the wiring difference, the ECM also requires a segment swap as that portion of the transmission control is completely different.
Are all 4L60E transmissions the same?
4L60E transmission bellhousings are not the same. One of the main differences in the earlier and later 4L60E transmissions is the bellhousing area. In the earlier versions, the case was cast as on piece of aluminum. In the later versions of it had a removable bellhousing.