How do you turn off a diesel engine without the key?
In diesel engines, the only way to stop the engine is to cut off the fuel supply. This can be done by stopping the pump or closing the inbuilt valve etc. In a petrol/gas/volatile liquid engine, you need to turn off or cut the power supply to the spark plugs.
What happens when you turn off the engine on a Mercedes diesel?
When you turn your key off, electrical power is interrupted and the engine quits immediately. Since a diesel engine does not run on electric spark, the engine has to be shut off by some other means. When you turn the key off on your Mercedes diesel, you may have noticed that the engine will not quit immediately.
Why is my ignition not working on my Mercedes Benz?
It is possible that the battery in the car is defective, as it does not provide the necessary voltage for the ECU and the N73 Electronic Ignition/Starter Switch (EIS) to function properly. If the battery is dead or has low voltage / under voltage, the CAN communication between EIS and N72 may not function properly.
Where does the vacuum go on a Mercedes 300D?
In all Mercedes diesel engines from the first 300D in 1975 up to the mid 1990’s, vacuum (suction) is used to turn the engine off – not electricity! In simple terms – there is a valve mounted on the rear or side of the diesel fuel injection pump. This valve has an arm attached to it that goes down inside the pump.
What causes a Mercedes Benz key to not turn?
List of common problems and possible solutions 1 Locked Steering Wheel. New drivers always experience this at least once, so we thought we would include it in this list. 2 Discharged Battery Undervoltage. 3 Key Tumbler Defective. 4 Defective Electronic Ignition/Switch System EIS / N73. 5 Smart Key Remote. …
What causes a Mercedes Benz ignition to not turn?
Mercedes EZS EIS Ignition Switch Problem, Cause, Solution. A problem that Mercedes-Benz owners may face is the key no longer turns in the ignition. This issue is often caused either by a defective key, bad shifter module, a failed Electronic Ignition Switch (EIS) also known as the EIS-EZS or a bad steering lock module (ESL).
When you turn your key off, electrical power is interrupted and the engine quits immediately. Since a diesel engine does not run on electric spark, the engine has to be shut off by some other means. When you turn the key off on your Mercedes diesel, you may have noticed that the engine will not quit immediately.
Can you replace the ignition switch on a Mercedes Benz?
Many owners go the route of installing ignition switch, ECU, shifter module and other parts from a donor vehicle. You can’t replace the ignition switch only with one from a used Mercedes-Benz. Several parts need to swapped because the stored VIN needs to be the same in all of them.
Why is my Mercedes EZs EIS ignition not working?
The only issue here is that if you can’t turn on the ignition, you can’t power on the OBD2 port and the iCarsoft MB II scanner. If the ignition turns on intermittently, consider yourself lucky and scan for codes. Hopefully, there are fault codes that will point you to the problem. Diagnosing Mercedes ignition problems isn’t a simple DIY job.