How do you scale assemblies in Solidworks?

How do you scale assemblies in Solidworks?

To save a SOLIDWORKS assembly as a part:

1. Open the newly saved multi-body part.
2. Access the Scale feature (Insert > Features > Scale).
3. Select all of the solid bodies in the part to be scaled – note you may need to access the Feature Manager and expand the Solid Bodies folder to select the bodies.

What are the scale sizes for models?

Models come in a range of scales, the most common being 1:4, 1:8, 1:12, 1:16, 1:18, 1:24, 1:48, and 1:72.

How do you find the scale factor of a model?

To find a scale factor between two similar figures, find two corresponding sides and write the ratio of the two sides. If you begin with the smaller figure, your scale factor will be less than one. If you begin with the larger figure, your scale factor will be greater than one.

Can you scale an assembly?

To scale an entire assembly model, it is possible to scale each part independently, however this could be extremely tedious for an assembly with a large number of components.

Can you scale parts in Solidworks?

You can scale a part or surface model about its centroid, the model origin, or a coordinate system. In a part document, click Scale (Features toolbar) or Insert > Features > Scale .

How do I change the scale in Solidworks 2016?

To set the scale of an existing drawing sheet, do one of the following:

1. In the status bar click Sheet Scale and click a scale.
2. Right-click the sheet and select Properties, then edit the values of Scale.

How do you scale blocks?

To Ensure Uniform Scaling in a Block Reference

1. Click Drafting tab > Block panel > Block Editor.
2. Open the block definition in the Block Editor.
3. In the Block Editor, make sure nothing is selected.
4. In the Properties Inspector, under Block, click Scale Uniformly.
5. On the drop-down list, select Yes.

How do I edit a block in Solidworks?

To edit a block:

1. Right-click the sketch and select Edit Sketch.
2. Expand the folder to display the blocks.
3. Select a block and click Edit Block.
4. Make changes to the block, and click the block confirmation corner.