How do you reset the shifting solenoid on a chevy S10?
How to Reset the Shifting Solenoid on a Chevy S10
- Shift the truck’s transmission into first gear (manual) or park (automatic). Turn off the engine and set the parking brake.
- Turn the ignition back to the “ON” position but don’t re-start it.
- Power on the scan tool and select “PCM” from the main menu.
How do I reset my 2003 Chevy S10?
To reset the computer all You need to do is disconnect the battery and touch the positive and negative cables together when they are off the battery for at least 10 minutes. This will drain the electricity out of Your vehicle’s electrical system and cause the ECU to lose power.
What year S10 has 4L60 transmission?
Second generation (1994)
| Second generation | |
|---|---|
| Powertrain | |
| Engine | 2.2 L LN2/L43 I4 4.3 L LB4/L35/LF6/LU3 V6 |
| Transmission | 4-speed 4L60-E automatic 5-speed Borg-Warner T-5 manual (1994–95 I4) 5-speed NV1500 manual (1996+ I4) 5-speed NV3500 manual (V6) |
| Dimensions |
Where is the speed sensor on a 2000 Chevy S10?
Locate the vehicle speed sensor. If you have a 2WD model, it is located on the transmission tailshaft on the driver’s side. On 4WD models, the sensor is mounted on the transfer case tailshaft (driver’s side as well.
How do you reset a GM transmission control module?
Steps to Resetting Transmission Control Module
- Step 1: Turning Key Position. Before resetting the transmission control module, it is necessary to check the key position.
- Step 2: Press gas pedal.
- Step 3: Keep Waiting.
- Step 4: Turning the Key Off.
- Step 5: Releasing Gas Pedal.
- Step 6: Wait Again.
- Step 7: Ready.
Where is the speed sensor located on a 4L60E transmission 4×4?
The transmission connector is located on the passenger side of the 4L60E transmission housing and on the driver side of the 4L80E transmission housing. The vehicle speed sensor is located in the tail shaft housing on the passenger side.
What is the shifting solenoid on a Chevy S10?
The shifting solenoid on a Chevrolet S-10 pick-up is designed to regulate when the transmission shifts. This solenoid is part of the electronic transmission control system, and is controlled by the powertrain control module, or PCM. The PCM actuates the shifting solenoid when it determines that an upshift or downshift is required.
Why is the reverse gear not working on my 4L60E?
Valve Body Issues- A bad valve body can make the reverse gear not work in the 4L60E. If the valve body ends up warped, or if the gasket fails, it’s entirely possible that the gear won’t engage. Booster Valve- A bad booster valve can leave you without reverse in a hurry. Sun Shell- A broken sun shell will cause…
What to do when 2.1-2 shift does not happen?
2. 1-2 shift does not happen at WOT (Wide Open Throttle) until you let off the gas: Best case: try replacing the TPS. Middle case: leak in the 2nd gear apply circuit (servo assembly or 1-2 accumulator). Double check by using the pressure gauge and watch for a big drop when the PCM commands 2nd gear.
What does DTC stand for on Chevy S10?
Power on the scan tool and select “PCM” from the main menu. Select “Transmission” from the PCM sub menu. Select “Clear all current and stored DTCs.” DTC is an acronym for “Diagnostic Trouble Code.” Disconnect the can tool from the vehicle and start the engine.