How do you reset the oil life on a Land Rover LR2?

How do you reset the oil life on a Land Rover LR2?

How do you reset oil service light Land Rover LR2.

1. Press and hold the trip reset button with the vehicle stationary and in a power mode less than 6 (two positions before starting engine).
2. While holding the trip reset button, enter the vehicle into power mode 6 (one position before starting engine).

How do you reset the oil light on a 2010 Land Rover?

How to Reset the Service Indicator On Land Rovers

1. Key on, engine OFF.
2. Open door.
3. Open bonnet (hood)
4. Depress the accelerator pedal simultaneously for ten seconds, release.
5. service interval is now reset.

How do you reset the oil life on a 2006 Land Rover LR3?

How To Reset Land Rover Discovery 3 LR3 Oil Service Light (2004-…

1. Put the key fob into its slot.
2. Press and hold the TRIP reset button.
3. Turn the ignition key to the “ON” position without starting the engine.
4. Keep press the TRIP button until SERVICE indicator start flashing and wait until it stop flashing.

How do you reset a Land Rover computer?

How do I perform a reset, when my screen is blank?

1. To reset the device, simultaneously press the Power on and Volume up button for 10 – 12 seconds.
2. The device will power down and then automatically reboot.
3. Device will now power on, perform and charge as expected.

How do you reset the oil light on a 2006 Range Rover?

Press and hold the trip odometer button in the instrument cluster (left button), and turn the ignition key to the first position (KLR). Keep the button pressed for approximately 5 seconds until one of the following words appear in the display: “OIL SERVICE, or “INSPECTION”, with “reset”.

How do you reset the oil light on a 2007 Land Rover LR3?

How do you reset a Land Rover?

How do you reset the check engine light on a 2008 Range Rover Sport?

Reset Your Check Engine Light: Disconnect the Battery

1. Turn off your vehicle and put on the proper safety gloves and glasses.
2. Locate your battery under the hood and find the negative terminal.
3. Use a wrench to loosen the negative terminal connector.
4. Carefully hold it to the side for 30 to 60 seconds.