How do you reset the oil life on a 2015 Honda Pilot?
Press the “SEL/RESET” button and the oil life reset mode will be displayed. Use the up and down arrows to select “RESET” and press the “SEL/RESET button. Display will disappear and oil life will be reset to 100%.
What oil does a 2015 Honda Pilot take?
Engine Oil
| Viscosity: | 0W-20 (All TEMPS) |
|---|---|
| Capacity: | 4.5 quarts (with filter)After refill check oil level. 4.2 quarts. w/ofAfter refill check oil level. |
| Torque: | 29 ft/lbs (Oil Drain Plug) Install a new washer on the drain bolt. |
What weight oil does a 2015 Honda Pilot take?
0W-20
Per the owner’s manual, the Honda Pilot will need premium-grade 0W-20 detergent oil with an API Certification seal on the container.
How much oil does a Honda Pilot 3.5 take?
Engine Oil
| Viscosity: | 0W-20 (All TEMPS) |
|---|---|
| Capacity: | 5.4 quarts. w/ofAfter refill check oil level. 5.7 quarts (with filter)After refill check oil level. |
| Torque: | 30 ft/lbs (Oil Drain Plug) Install a new washer on the drain bolt. |
How to change oil life on Honda Pilot?
Set display panel to oil life. Hold the reset button located on steering wheel for 5 to 10 seconds. Display panel will beep and then show ‘cancel’ on top of ‘reset’. Arrow down to reset, and hit the reset button on steering wheel again.
How to turn off maintenance light on Honda Pilot?
To turning off the Oil Change Maintenance Light on 2011, 2012, 2013, 2014, 2015 Honda Pilot, conform to the following instructions: Turn the ignition switch to the “On” position, but do not start the engine Press SELECT/RESET knob until the engine oil life indicator is appear on the display
Who is the owner of the Honda Pilot?
8 The Bluetooth ® word mark and logos are owned by the Bluetooth SIG, Inc., and any use of such marks by Honda Motor Co., Ltd., is under license. 10 Audio memory is a component of navigation system’s hard disk drive (HDD).
How to reset Honda Element maintenance light after oil change?
If the engine oil life is not displayed press the SEL/RESET knob in the instrument panel repeatedly until it is Press and hold the SEL/RESET knob in the instrument panel for about 10 seconds or until the maintenance item code (s) begin to blink