How do you reset the check engine light on a 2012 Kia Soul?
To reset the Check Engine light, you can remove the “NEG” cable from the battery for a minimum of 5 minutes. Keep in mind- if the reason why the light is on was not addressed, or was repaired incorrectly, the light WILL return within 50-75 miles of driving (sooner, depending on where the problem lies).
What to do when check engine light is on on Kia Soul?
The video above shows how to locate the on board diagnostics (OBD) plug on your 2012 Soul, how to read the trouble codes and how to reset or clear the check engine light using a scanner on your Soul. Intermittent Check Engine Light: If the check engine light on your 2012 Soul is intermittent, try to take note of the conditions when this happens.
Why does my Kia Sedona have a check engine light?
Kia Check Engine Light (CEL) (also known as Service Engine Soon SES or MIL) may sometimes turn on and stay on when driving. This problem can effect Kia models such as: Sedona and other models.
How long does it take for check engine light to go off?
If you are sure you have fixed the problem, it takes around 10-30 successful cycles before the check engine light disappears. One process is one cold-start until the engine is warm. Will the check engine light go off by itself? Yes, The check engine light will reset itself after a fixed amount of time if you fixed the problem in most car models.
How can I read the Check Engine Light code?
You can read Kia check engine light codes yourself using an OBD-II scanner. This method applies only to Kia vehicles that are the model year 1996 and newer. Locate the OBD-II port under the dashboard. Plugin your scanner into the OBD-II port. Turn on the ignition. Do not start the engine.
What if the Check Engine Light is on?
If the check engine light comes on, here are some tips on what you should do: Look for a serious problem that requires immediate attention. Check your dashboard gauges and lights for indications of low oil pressure or overheating. Try tightening your gas cap. This can often solve the problem. Reduce speed and load. Use built-in diagnostic services, if available.
How to ckeck engine light codes?
Chevy Check Engine Light Codes Connect scan tool to the 16-pin data link connector (DLC) located underneath the steering column. The connector may have a removable cover. Turn the ignition on. Follow scan tool manufacturer’s operating instructions to access the Diagnostic Trouble Codes (DTC’s).
What’s a check engine light?
The check engine light – more formally known as the malfunction indicator lamp – is a signal from the car’s engine computer that something is wrong .