How do you replace clutch on Raptor 660?
Cover the hole (case side) that is open to the transmission to stop debris from entering. Clean both surface carefully and wipe clean with rubbing alcohol. Also clean the shaft surface and make sure all debris is removed. If you removed the wiring harness gasket, put sealant on one side and replace.
Where are the bolts on a raptor starter clutch?
Loosen the nine bolts in a criss-cross pattern so as to avoid warping the cover. Once all are loose, remove them. The bolt farthest to the left is securing the Raptor’s ground wire, so disconnecting the battery is also recommended. You may have to rock the cover back and forth to get it loose.
What should the nut be on a Raptor 660?
Grab your strap wrench and place it on the flywheel and tighten the nut to 110 ft/lbs or 150 N/m. Once again, you may need a helper to hold the rear brake and the bike may need to be in gear. Make sure everything is well lubricated.
Where is 52 tooth idler gear on Raptor 660?
Pull the 52 tooth (large gear behind the flywheel) idler gear off the shaft. If you have a 2001, remove the needle bearing and set aside. You will not reuse this bearing if you purchased a kit. The gear we sent to you is ready to go with a pressed in brass bushing. Check the bearing surface for wear and pitting and replace if worn.
What to do if your Raptor 350 clutch slips?
Loosen the clutch cable and see if the slipping occurs again, before attempting to replace the clutch. Do not ride your Raptor 350, if you suspect that the clutch is slipping. A slipping clutch is unreliable and can cause a loss of control, if the clutch slips then grips suddenly.
What happens when the clutch is engaged on a raptor?
When the clutch is engaged, these plates are pushed against a housing mounted on the end of the engine’s crankshaft. This transfers the engine’s power output to the transmission. When the clutch plates wear, they begin to slip against each other, causing a delay in power that affects the performance and safety of your Raptor.
How do you take the clutch plate out of a car?
Push the bearing and the clutch push rod out of the outer clutch plate. Hold the clutch assembly in place, using a clutch holder tool. Remove the nut from the center of the clutch boss, the plate that retains the clutch plates, using a 19 mm socket. Pull the clutch boss and the clutch plates out of the clutch assembly.
How many clutch plates are in a clutch boss?
Remove the nut from the center of the clutch boss, the plate that retains the clutch plates, using a 19 mm socket. Pull the clutch boss and the clutch plates out of the clutch assembly. In total, there will be 13 clutch plates and two spring cushions in the stack of plates.