How do you remove a belt from a Lexus?
While holding the tool in place to keep tension off, pull the belt of whichever pulley is closest to you. Once the belt has been removed from a pulley, release tension, get the tool out of the way, and remove the belt from the other pulleys.
What does the serpentine belt do on a Lexus IS?
This article applies to the Lexus IS and GS (2007-2014). The power to your alternator, power steering, and air conditioning is all delivered by the serpentine belt.
Where is the cheater bar on a Lexus?
Socket on the tensioner bolt (notice the mess caused by removing the upper radiator hose). With the cheater bar on the end, get it as close to the air intake as possible. The handle of the tool should be pointed to the passenger side of the car.
How do you change the drive belt on a Lexus LS400?
Put one wrench on a nut to use it for leverage. Use the other wrench on another nut to remove it. Mess around with it and you’ll figure it out. 5) Using a 14mm socket, turn the belt tensioner counter-clockwise with one hand and slip the drive belt off with your other hand.
How to remove the crankshaft pulley on a Lexus?
To remove the crankshaft pulley you might need a compressor if you are doing the job alone. Otherwise all u need a strength in your hands. To get the crankshaft pulley out you have to rent a special tool caller “harmonic balancer pulley removal kit”. The rent is free at Autozone. Parts.
How do you change the water pump on a Lexus LS400?
Use a strong screwdriver or pry bar between the water pump and cylinder block to pry it off, be careful not to damage the block. Clean all the old sealant, grease, coolant, and dirt off the cylinder block. Here’s what it will look like with the water pump removed and everything cleaned up. 29) Replace the O-ring on the water by-pass pipe.
How many miles does a Lexus LS 400 have?
Car is a 1996 Lexus LS 400 with 115k miles. Click Here for First Generation Timing Change The most important thing is put the parts that you take out in the order they were removed otherwise its really easy to get lost and you can have some extra parts after assembly. In order to get this done you need a big 500 piece set of tools.