How do you program a key fob for a 2006 Saturn Ion?
At this time, press and hold both the lock and unlock buttons on your keyless remote. You may need to hold these buttons for as much as 30 seconds until the vehicle again responds by cycling the locks. Release the buttons once the locks cycle and that remote will be successfully programmed.
How do you program a Saturn key fob?
Repeat the programming sequence–by holding the lock and unlock buttons–on your next remote. Do this within one minute and wait for the locks to cycle again to indicate successful programming. Repeat again with any additional remotes, up to four, and be sure to do it within a minute and wait for the locks after every remote.
How long does it take to program a Saturn Remote?
Release the buttons once the locks cycle and that remote will be successfully programmed. Repeat the programming sequence–by holding the lock and unlock buttons–on your next remote. Do this within one minute and wait for the locks to cycle again to indicate successful programming.
Where is the data port on a Saturn?
Insert your key into the ignition and leave the key in the “Off” position. Locate the car’s data port on beneath the dash board panel on the driver’s side. Notice the eight data terminals on each side of the port and connect the jumper wire to the 8 and 4 terminals, which are eighth and fourth from the left side of the port on the top side.
Repeat the programming sequence–by holding the lock and unlock buttons–on your next remote. Do this within one minute and wait for the locks to cycle again to indicate successful programming. Repeat again with any additional remotes, up to four, and be sure to do it within a minute and wait for the locks after every remote.
Release the buttons once the locks cycle and that remote will be successfully programmed. Repeat the programming sequence–by holding the lock and unlock buttons–on your next remote. Do this within one minute and wait for the locks to cycle again to indicate successful programming.
Insert your key into the ignition and leave the key in the “Off” position. Locate the car’s data port on beneath the dash board panel on the driver’s side. Notice the eight data terminals on each side of the port and connect the jumper wire to the 8 and 4 terminals, which are eighth and fourth from the left side of the port on the top side.