How do you pop the hood on a Mazda 3?
Opening the Hood Insert your hand into the hood opening, slide the latch lever in the direction of the allow as shown in the illustration, and lift up the hood. Grasp the support rod in the padded area and secure it in the support rod hole indicated by the arrow to hold the hood open.
Can a Mazda 3 have a dead battery?
Mazda’s are not known for battery problems. With that said, chances are either your new battery is not fully charged or it is a dud. It is most likely not fully charged. I suggest that you get it fully charged. As for the jumper, that is always a nice accessory to own regardless of which car you drive.
What should I do if my Mazda 3 engine stalls?
Very cool, congrats on fixing it! cleaned it with a rug soaked in 100% ethanol, took about 25 min to remove all carbon deposit. start it up and let it idle for 20+ minutes. at 20 minutes, turn the ac on. extended idle time will give the pcm time to relearn idle strategy. even if you havent cleaned the throttle body.
What should I do if my car battery is dead?
Your situation is odd. The battery should not be dead after one week, month or even 6 months if it’s new. Once you get the car started and it’s a good battery then the battery will charge itself to full assuming you drive the car long enough. Consider checking any interior lights are on.
Mazda’s are not known for battery problems. With that said, chances are either your new battery is not fully charged or it is a dud. It is most likely not fully charged. I suggest that you get it fully charged. As for the jumper, that is always a nice accessory to own regardless of which car you drive.
How to replace a battery in a Mazda 6?
Remove Bracket – Take off the bracket that secures the battery Car Displayed: 2006 Mazda 6 i 2.3L 4 Cyl. Sedan (4 Door) 5. Remove Cables – How to disconnect the cables the right way
Where can I find the Mazda battery code?
Check for this code in your owners manual – it will usually be either a sticker or small card in the booklet. If you can’t find it, call Mazda and they will give you the code for free.
Very cool, congrats on fixing it! cleaned it with a rug soaked in 100% ethanol, took about 25 min to remove all carbon deposit. start it up and let it idle for 20+ minutes. at 20 minutes, turn the ac on. extended idle time will give the pcm time to relearn idle strategy. even if you havent cleaned the throttle body.