How do you install a floor shift cable?
turn the lock, separate the shift cable from the shift lever retainer. Separate the end of the shift cable from the shift lever assy. Remove the 2 bolts and retainer from the floor. pull out the control cable assy from the floor. Remove the retainer from the grommet. 6. Install floor shift cable transmission control shift
How to replace the floor shift cable on a Toyota Corolla?
Connect air bag sensor assy center install the airbag sensor assy center with the 3 bolts. Torque: 17.5 Nvm (178 Kgf·cm, 13 ft·lbf) 10. Inspect srs warning light Replacement Hint: components: 1. Remove floor shift shift lever knob sub–assy 2. Remove console panel upper 3. Remove parking brake hole cover sub–assy 4.
How to remove shift cable from Jeep Liberty?
Transmission shall not be able to shift from NEUTRAL to REVERSE. (1) Shift transmission into PARK. (2) Raise vehicle. (3) Remove the shift cable eyelet from the transmission manual shift lever (Fig. 159). (4) Remove shift cable from the cable support bracket. (5) Lower vehicle.
Where is the floor shift on a Jeep Liberty?
(1) The floor shifter lever and gate positions should be in alignment with all transmission PARK, NEUTRAL, and gear detent positions. (2) Engine starts must be possible with floor shift lever in PARK or NEUTRAL gate positions only. Engine starts must not be possible in any other gear position.
turn the lock, separate the shift cable from the shift lever retainer. Separate the end of the shift cable from the shift lever assy. Remove the 2 bolts and retainer from the floor. pull out the control cable assy from the floor. Remove the retainer from the grommet. 6. Install floor shift cable transmission control shift
Where is the shift cable on an automatic?
Floor shifters mounted on the floor column are operated by the handle on the shifter. A cable connected from the shifter to the transmission changes the gears in automatic transmissions. Aftermarket floor shifters are available from any auto parts store in your area.
Connect air bag sensor assy center install the airbag sensor assy center with the 3 bolts. Torque: 17.5 Nvm (178 Kgf·cm, 13 ft·lbf) 10. Inspect srs warning light Replacement Hint: components: 1. Remove floor shift shift lever knob sub–assy 2. Remove console panel upper 3. Remove parking brake hole cover sub–assy 4.
How do you remove a floor shifter from a car?
Remove the screws from the sides of the floor shifter using the 1/2-inch wrench. Use the small flat-head screw driver to pry the locking clip loose from the shifter handle. Raise the handle to remove it. Raise the console and remove the four screws at the bottom of the console. Raise the console up to reach the floor shifter.