How do you clear a code on a Nissan Maxima?
How to Reset the ECU (Service Engine Soon Light) on a Nissan Maxima
- Turn the ignition switch to the on position but do not start the car.
- Count seven seconds, depress the gas pedal and hold it down for 10 seconds or until the service engine soon light begins flashing.
Where is the Diagnostic Code on Nissan overheat warning lamp?
Check that Overheat Warning Lamp is displaying Diagnostic Display Code. Connect memory clear connector 2400400Z09, or a suitable jumper wire to reset switch terminals. The reset switch is located behind the electrical unit board. Check that Overheat Warning Lamp and Buzzer display shows Diagnostic Display Code 0–1.
How long does it take for a Nissan OBD code to appear?
For example, a code 12 will be displayed by the check engine lamp flashing 1 time for approximately 1.2 seconds, followed by a .6 second pause, then 2 short flashes. Each trouble code will be displayed 3 times before the next trouble code is displayed.
Where do I find the trouble code on my Nissan?
On all models, to erase DTCs using generic scan tool (GST), select mode 4. Place diagnostic switch in the Off position. Place ignition switch in the On position. Crank engine. Start and operate engine. The trouble codes will be displayed by the flashing Engine Control Lamp and the Overheat Warning Lamp and the Overheat Warning Buzzer.
Where is the OBD code on a Nissan Leaf?
(Mode II): with engine stopped, system in self diagnostic results state. with engine running, system in front O2S monitor state. Turn ignition Off. Connect ‘‘Consult’’ the data link connector (DLC), located behind fuse box cover. Turn ignition On.
Where can I find the OBD code on a Nissan Maxima?
Nissan Corporation OBD I diagnostic page explains how to get the codes without any special tools. The codes are listed seperately for Maxima and Sentra models as needed. The codes are defined as to what system is affected. When possible we give the more commonly known OBD II component name.
How to clear engine OBDII Codes without Nissan consult?
ECM has entered to Diagnostic Test Mode II (Self-diagnostic results). How to clear the engine codes without a Nissan CONSULT or scan tool. Set ECM in Diagnostic Test Mode II (Self-diagnostic results). Fully depress the accelerator pedal and keep it for more than 10 seconds.
For example, a code 12 will be displayed by the check engine lamp flashing 1 time for approximately 1.2 seconds, followed by a .6 second pause, then 2 short flashes. Each trouble code will be displayed 3 times before the next trouble code is displayed.
On all models, to erase DTCs using generic scan tool (GST), select mode 4. Place diagnostic switch in the Off position. Place ignition switch in the On position. Crank engine. Start and operate engine. The trouble codes will be displayed by the flashing Engine Control Lamp and the Overheat Warning Lamp and the Overheat Warning Buzzer.