How do you change the throttle grip on a Harley?
adjust the throttle cable adjuster so that the throttle body butterflies hit the wide open stop just as the throttle grip reaches wide open throttle (WOT). snug the lock nut on the throttle cable adjuster. adjust the idle cable adjuster to remove excess slack from the throttle grip, but not so tight as to cause the grip to bind.
What kind of grips do you use on a Harley Davidson?
We will remove the stock grips on a Harley and install the Kuryakyn Kinetic grips. This motorcycle has throttle cables and you will need the correct grip for the throttle grip. We do cover how to change grips on a Harley with electronic throttle control in a separate video.
How can I Reset my throttle position sensor?
Reprogramming or resetting your sensor can sometimes solve these issues. This step can also be necessary when you install a new sensor. The easiest way to reset your throttle position sensor is to unhook the negative cable from your battery for up to five minutes or to remove the fuse for your engine control module.
How to reset throttle body calibration [ step by step guide ]?
Make sure that the accelerator pedal is fully released. Turn ignition switch “ON” and wait at least 2 seconds. Turn ignition switch “OFF” wait at least 10 seconds. Turn ignition switch “ON” and wait at least 2 seconds. Turn ignition switch “OFF” wait at least 10 seconds.
adjust the throttle cable adjuster so that the throttle body butterflies hit the wide open stop just as the throttle grip reaches wide open throttle (WOT). snug the lock nut on the throttle cable adjuster. adjust the idle cable adjuster to remove excess slack from the throttle grip, but not so tight as to cause the grip to bind.
Can you remove stock grips on a Harley Davidson?
For most bikes, removing the stock grips is a pretty simple process. On the throttle side you’ll likely have a housing of some sort that you’ll need to remove and then the grip will slide right off. It’s possible, however, that you’ll have an application where there’s a tube inside the throttle grip that will need to be saved.
Can you change the handlebar on a 1998 Sportster?
A new handlebar can refresh the look of even a 1998 Sportster and make it look a decade newer for only about $80! The work can easily be done at home with only some two torx wrenches and a hex key. If you want to show your support for the tips, tricks, and info we put out, please Subscribe to our new YouTube channel here.
How to replace clutch side grip on Harley?
Clutch Side. 1 Slide clutch side grip into place. 2 Mark location for drilling divots. 3 Remove grip, drill divots. 4 If desired, apply grip adhesive to bar. 5 Slide grip into position, tighten placement screws. 6 Allow glue to dry according to directions.