How do you change the oil in a Heritage Softail?
Unscrew the drain plug with a 5/8-inch socket and a socket wrench, or loosen the drain hose clamp with a flat-head screwdriver and pull out the hose plug. Allow your Heritage Softail’s oil to drain for a minimum of five minutes or until the flow of oil slows to a thin trickle.
How do you change oil on a Softail Fork?
Lift the bike up, locate the drain screw on the backside of the fork near the bottom of the fork. Remove the screw, of course have a drain pan under to catch the oil. To remove the screw, you need a well fitting bit (any ones I have ever done were phillips head) and I always use an impact driver on the drain screw.
What kind of oil does a heritage Fork take?
The type E oil is very light. HD has a couple of heavier Screaming Eagle oils that are heavier and I have found they work much better in my Heritage. The forks don’t bottom out and the handling is much better, especially in cornering. I believe the type E is a 5 wt. oil and the SE oils are 10 wt. and 15 wt. if I remember correctly.
How much oil does a Harley Davidson Fork need?
and for FLHR/C (conventional fork type) it ask for 11 oz or325 ml and 4.92 in . Need to know how much fork oil needed in 2007 FLSTC. Have repair manual that says let Harley mechanics do .Not! I repaired tubes already and have Screaming Eagle heavy fork oil. Can I use this and if so how many ounces? Click to expand…
What kind of fork oil do you use on a Softail?
The capacity varies by model but for most Softails and Dynas this amount is about 9 to 10 oz. If using Harley brand fork oil then type “B” or “E” is recommended depending on the model. The alternative product for those who require superior performance is Shock Therapy #10 Fork Oil which can be used in place of either type oil.
What kind of oil does a Harley Davidson Fork take?
I Am Replacing My Front Fork Springs With Progressive On 2000 Vulcan 1500v Clic The Owners Manual Does
What do I need to change oil on a Harley Davidson Softail?
Materials Needed Replacement oil (either Dino or synthetic will do) Catch pan Replacement oil filter Shop rags Oil filter wrench (optional) Torque wrench Motorcycle lift or 2×4 block of wood (optional)
Can a Harley Davidson shovelhead Fork be rebuilt?
As some of you may know from following me on Facebook, Twitter, or Instagram, I am neck deep in a front-end rebuild of my 1972 Harley-Davidson Shovelhead FLH . I have completely disassembled both fork legs, methodically cleaned each internal part, and ordered the replacement parts necessary to put things back together.
Where is the oil drain plug on a Softail?
Softail models built between 1984 to 1999 are equipped with an Evolution engine, which uses an oil drain hose placed in front of the transmission unit, on the left side of the motorcycle. Softail models built after 2000 are equipped with the newer Twin Cam engine, placing the oil drain plug on a cross-member below the rear of the transmission unit.
What should the drain plug be on a 2007 Harley Davidson?
My question is when there is a range , for instance transmission drain plug , 14-21 ft. Lbs , is it best to stay in the middle of that range or stay up towards the top of the range . 14-21 is or seems to be a big difference . Keep in mind this is the one for the 2007 modeles .
How do you change oil on a Harley Davidson Softail?
Warm your Heritage Softail’s engine and oil. Start the engine and let it idle in place for three minutes, then stop the engine. Mount your Heritage Softail on a service stand, or place a 3-inch block of wood under the motorcycle’s side stand to elevate it into an upright position.
When to change the oil on a 2008 Heritage Classic?
Discussion in ‘ Softail Models ‘ started by 2006FXDCI, Jul 14, 2011 . Friend of mine has a 08 heritage classic and wants his oil changed. He doesn’t have a service manual so I was wanting to know the procedure for changing the oil and also need info on how much oil it takes.
Where can I get Used oil for a 2007 Harley Davidson?
Contact the store first to ensure its collection facilities are available to receive used oil. These instructions were based on a 2007 Heritage Softail model, but the process is similar for other makes. Failure to use factory-approved motor oil and filters may void your warranty. Consult your dealer if you have any questions.
Unscrew the drain plug with a 5/8-inch socket and a socket wrench, or loosen the drain hose clamp with a flat-head screwdriver and pull out the hose plug. Allow your Heritage Softail’s oil to drain for a minimum of five minutes or until the flow of oil slows to a thin trickle.
Warm your Heritage Softail’s engine and oil. Start the engine and let it idle in place for three minutes, then stop the engine. Mount your Heritage Softail on a service stand, or place a 3-inch block of wood under the motorcycle’s side stand to elevate it into an upright position.
Contact the store first to ensure its collection facilities are available to receive used oil. These instructions were based on a 2007 Heritage Softail model, but the process is similar for other makes. Failure to use factory-approved motor oil and filters may void your warranty. Consult your dealer if you have any questions.
Where is the oil drain on a Softail?
Softail models built between 1984 to 1999 are equipped with an Evolution engine, which uses an oil drain hose placed in front of the transmission unit, on the left side of the motorcycle.
Where is the Softail on a Harley Davidson?
Softail Shock Adjustment. Positioned horizontally under the motorcycle, the shock is mounted to the frame in the front of the bike and to the swing arm in the rear. As the shock compresses, the bike gets taller. As the shock extends, the bike stands lower. The rear shock spring preload may be adjusted to the total load,…
How to remove tail light from Harley Davidson Softail?
Once the tail light is off, disconnect the quick release wiring harness by pushing in on the tab and pulling apart. Figure 1. Use a Phillips head screwdriver to remove the screws from either side of the tail light to remove it from the bike. Figure 2. Release the quick disconnect wiring harness and set the tail light to the side.
How much does a Harley Davidson Heritage Softail cost?
General information Model: Harley-Davidson FLSTC Heritage Softail C Year: 2010 Category: Touring Price as new: US$ 16999. MSRP depends on country, taxe
Can you change the exhaust on a Harley Davidson Softail?
One of the most popular modifications you can do to your Softail is change the exhaust to your particular style. This article applies to the Harley Davidson Softail. You have the quintessential motorcycle. What more could you want?
How to do an oil change on a Harley Davidson Softail?
Follow along as Bob teaches you how to drain the fluids on your Harley Softail, including the primary, engine oil and the transmission drain plugs. You’ll also learn how to expertly reinstall the oil filter, and which parts must be replaced each time you perform a Harley Davidson oil change and service your motorcycle.
How much fluid do you put in a Softail transmission?
A small amount of metal shavings on the drain plug magnet is normal. Inspect the fill plug o-ring for damage and replace if necessary. Place a funnel into the fill plug hole and pour 22 oz. (650 milliliters) or 32 oz. (946 milliliters) of fluid into the transmission (differs by year).
Where to drain transmission fluid on a Harley Davidson?
Locate the drain plug between the shocks on the bottom side of the transmission. It’s difficult to see and access, but with a 3/8″ ratchet, 6″-8″ extension, universal joint, and a 5/8″ socket, it can be removed. Place your drain pan underneath the bolt. Once the fluid is almost completely drained, level out the bike to remove any remaining fluid.
Follow along as Bob teaches you how to drain the fluids on your Harley Softail, including the primary, engine oil and the transmission drain plugs. You’ll also learn how to expertly reinstall the oil filter, and which parts must be replaced each time you perform a Harley Davidson oil change and service your motorcycle.
Where is the drain plug on a Harley Davidson Softail?
Locate the drain plug between the shocks on the bottom side of the transmission. It’s difficult to see and access, but with a 3/8″ ratchet, 6″-8″ extension, universal joint, and a 5/8″ socket, it can be removed. Place your drain pan underneath the bolt.
Locate the drain plug between the shocks on the bottom side of the transmission. It’s difficult to see and access, but with a 3/8″ ratchet, 6″-8″ extension, universal joint, and a 5/8″ socket, it can be removed. Place your drain pan underneath the bolt. Once the fluid is almost completely drained, level out the bike to remove any remaining fluid.
How do you get the oil out of the tank?
Push down on the oil tank filler cap, then twist the cap counterclockwise to unlock it from the oil tank filler neck. Pull the cap and its attached dipstick out of the oil tank to vent the oil system. Locate the oil drain plug.
How much does it cost to change oil on a Harley?
A bike lift such as this will set you back less than $200 and it will pay for itself after just a couple of oil changes. Warm up your bike a little, as this will help thin the oil and let it flow faster. Once the bike has been running for a couple of minutes, shut it down and then remove the integrated oil fill cap and dipstick.