How do you adjust the throttle cable on a motorcycle?
To adjust the throttle cable: Loosen the locknut. Tighten or loosen the adjuster to get the right amount of play. Turning the adjuster in will give you more slack. Turning the adjuster out will tighten the cable. Tighten the lock nut. Confirm the adjustment.
What happens if the throttle cable is too loose?
The throttle cable will naturally loosen up overtime, so it’s important to check the throttle slack periodically. A cable that’s too loose will have poor throttle response and may feel sluggish or weird at WOT. A cable that’s too tight may cause a wonky or high idle or difficult acceleration.
How much slack do you need in throttle cable?
Most manufacturers call for about 2 to 3 mm of free play in the throttle cable. The throttle cable will naturally loosen up overtime, so it’s important to check the throttle slack periodically. A cable that’s too loose will have poor throttle response and may feel sluggish or weird at WOT.
How do you adjust the throttle cable?
Pull the throttle cable to its attachment point on the throttle. Adjust the cable by moving it until it lines up exactly with the attachment point.
How to check and adjust the throttle?
- Check Your Initial Throttle Cable Slack. Measure the initial free play of your throttle.
- Find Your Adjusters. Find your adjuster on your throttle cable or look by your carb or throttle body.
- Make Small Changes At The Barrel Adjuster. Smaller changes can be made at the barrel adjuster on your throttle cable.
- Check If Your Cable Is Kinked Or Pinched.
How does your motorcycle throttle cable work?
Motorcycle throttle cables consist of two steel cables that run from the grip of the throttle to the engine, to open and close the carburetor. Drivers use these two cables, the front cable and the idle-hand throttle cable, to accelerate the bike, just like a pedal is used to accelerate a car.
What is a transmission throttle valve cable?
The throttle valve cable is a key component of a transmission system. The throttle valve cable is responsible for maintaining proper shift feel, controlling line pressure, and both partial and full throttle downshifts. The throttle valve cable is connected to the throttle lever, and is responsible for controlling it.